are you serious? yeah you do- the O/D switch is on the side of the shifter- and if you're asking this I'm assuming you have an automatic....'cause a manual- well yeah you have to shift.
There is no "switch". To cancel overdrive move the gear lever from "D" to "4".
Its near the gear....a button with ECT written on it...
left side tranny
Disconnect the 2 wires from the switch and connect them together
That would be the OVERDRIVE selector switch.
the flasher? open the steering wheel
You have to use it when you are driving in mountain areas where to have high speed is not a good idea. The overdrive function does allow the transmission to switch to higher gears.
If the vehicle does not have an overdrive, then realistically, you can not.
The one new feature about the 2013 Toyota 4 Runner is that the transfer case has a new switch type control, replacing the former pull lever. Everything else is the same as for the 2012 model.
You have to remove the cover on the steering column that surrounds the switch.. Usually a pin or screw holds the switch in place. Make sure you have the correct switch from Toyota. If it helps any,,go out and buy a Haynes Manual for the truck. It will show you the procedure step by step.
The Oil Press. Switch is just forward and above about an inch of the oil filter. There is a single wire coming out of it. AZinAK
We are handing a claim on a 2007 Toyota truck. This party was rear ended and now states her vehicle won't start. Minor rear end accident. does this vehicle have a kill switch????