No- but you do have to be ambidextrous. My 93 Ranger is a bear, so I always replace with the best plugs I can find. Having different lenghts of socket extensions is also a must.
spark plugs are located in the side of the head you remove them with a spark plug socket tip for you if you dont know where spark plugs are or how to remove them, i would get someone that does know, to do it or at least show you
Disconnect the battery, remove the cables and boots, and remove the old spark plugs. Put in the new spark plugs, attach the cables and boots, and connect the battery.
Disconnect the battery, remove the spark plug cables and boot covers, and remove the old spark plugs. Next, put in the new spark plugs, reattach the boot covers and spark plug cables and reconnect the battery.
Disconnect the battery to the vehicle, remove the spark plug cables and boot covers, and remove the old spark plugs. Next, carefully put in the new spark plugs, attach the boot covers and spark plug cables and reconnect the battery.
There are ( 6 ) spark plugs
5/8 plug socket
The front exhaust manifold is right in front by the spark plugs. The rear manifold is behind the engine by the spark plugs.
Do this one plug at a time, and reconnect that wire so as to not get wires mixed up. REMOVAL Remove spark plug wires from spark plugs with a Spark Plug Wire Remover tool, pull outward on the boot with a slight side-to-side twist. Loosen spark plugs and remove any dirt or foreign material from spark plug areas of cylinder head with compressed air. Remove spark plugs. INSTALLATION Inspect and adjust spark plugs. Spark Plug Gap: 0.042" to 0.046". Install spark plugs. Tighten spark plugs to 9-20 N.m (7-15 lb in). Connect spark plug wires to spark plugs.
Change your spark plugs!!
To remove the stuck spark plugs, you can break them loose and then start to get them tighter as you rotate them out. The ratchet wrench can also be used to remove the stuck spark plugs.
Remove the fuel tank, Remove air box, Remove spark plug caps, Remove spark plugs ????
Its an 8 cylinder motor. Answer The 2.5 L - 4 cylinder engine used in the 1999 Ford Ranger has a twin plug ignition system , two spark plugs per cylinder , one plug fires for combustion , the second plug fires on the exhaust to achieve lower emissions