Want this question answered?
Begin by removing the tire and wheel from your 1993 Honda Civic. Remove the brake assembly and the brake rotor. Remove the axle retaining bolts. The axle will come off.
How do you remove the front axle on 1998 Honda 450 foreman?Read more: How_do_you_remove_the_front_axle_on_1998_Honda_450_foreman
front or rear rotor? jack up wheel that needs rotor removed. remove wheel remove brake pads and caliper for back axle, remove axle nut. u will need special socket to remove this nut slide rotor off axle, making sure u dont drop bearings on the ground to remove front rotor on4x4, it is pretty much the same as rear , except you will have to remove locking hub from axle before you can remove axle nut.
no, remove the caliper and the caliper mountaing bracket, if it is on the front you may have to remove the axle not but there is no need to remove any steering part
How do you get the axle out to change the boots on the cv joints
Jack up the Odyessy. Remove the wheel and the brake caliper. Take the brake rotor off. Remove the axle nut cover, and the cotter pin. Remove the axle housing. Replace the inner and outer bearings as well as the races.
remove axle nut in center of wheel before jacking it up then raise and support vehicle on stands and remove front tire then caliper and rotor then rotor mounting bracket remove bottom ball joint from the front spindle and you should be ready to pull the axle out then just reverse these steps to reinstall. hopefully this helps you
No it is not necessary to remove the axle nut in order to remove the front caliper. Once you remove the caliper the rotor should come off.
Jack up the front of the Vitara and remove the wheel. Unbolt the caliper and swing it out of the way, hang it with a piece of wire or coat hanger to keep pressure from the brake lines. If the rotor is the slide on type, just wiggle it to pull off. If it has the axle bearing race built in, then take off the axle nut, and slide the rotor off of the axle shaft.
Yes, if you remove the front axle first.Yes, if you remove the front axle first.
-remove right side tire and jack the front of the car up and put on stands. -remove axle nut (the big nut in the center of the brake rotor) -remove 2 bolts located under the knuckle -remove the sway bar link kit -push the the knuckle assembly off the lower control arm -wiggle off ( or tap on shaft ) while trying to slide cv axle out of the tranny.
The front wheel hub on a 1994 Honda Civic is connected to the upper control arm and lower. Remove those as well as the axle. Also remove the brake caliper, rotor, and pads. The hub will come off and the studs will then be able to be reached.