no , if you remove the rear hub there will be four 13 mm bolts holding the retaining plate in place , remove these bolts and the rear axle will slide out , if the rear brakes will not release fully you can remove the nuts from the rear and pull hub and all at one go though be very careful if this manner is attemted
how do i replace front wheel bearings on golf 1.6 2002 model
sorry to have to tell you this but the bearings are part of the wheel hub and sealed within. you need to change the entire hub. $$$$$$$
you don't they are sealed bearings. they will need pressed out of the hub to change them.
No, the rotor comes off by itself.
50-70 each
Remove the wheel, caliper, and rotor (you may also have to remove the wheel bearings depending on the specific model). The wheel speed sensor is attached to the end of the wire facing the wheel hub.
Follow this link. http://www.autopartsdirecttoyou.info/?p=3 it shows details for a Ford. But it will also get you thru a Trailblazer.
Front wheel bearings are a sealed unit. so the answer is no. run them till you wear em out.
I don't see why not. Unless is press in. Then you will need to have a press or take it to a shop to be press in.
breaks are off what's the next step to changing wheel bearings
Changing wheel bearing from a 2002 Hyundai Elantra requires removing the hub assembly. The bearing will need to be pressed out and in to confirm and safe install.
Do I need any special tools to replace front wheel bearings on a Saturn 2002 L200?Also what is the procedure for doing so?