0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Will a 97' jetta tdi ecu fit a gli 97' jetta?
No. Anytime you swap ecu's make sure the numbers match and if you have the anti thief ignition or key with diode you will need to have the ecu reprogramed by a lock smith or dealer to get the car to start.
How do you re-flash the ecu on a Dodge Magnum?
Take it to the dealer.
Is the Engine ECU on a 2001 Chrysler Sebring a simple plug-in to install?
If you have chip keys, the dealer will need to program the keys to the new PCM.
Does an ecu need programming if replaced for a 1994 Volvo 960?
No, just make sure the replacement ECU is from that year/model. There are differences in the 2.9 engines from 1995 through 1997 than the earlier 960 2.9l engines.
How do you disable the Immobilizer Theft Deterrent System on a 2002 Volkswagen Cabrio as now the car will not start after attempting to use the valet key?
The immobilizer can not be disabled, You will need to go to the VW dealer and have the key re-programmed. If it is the correct key.This problem can occur when the dealer replaces the ECU module - they sometimes forget to tell you that they will need ALL the keys to get them recognized as valid by the ECU.
How do you change the Fiat punto ECU?
fiat punto ecu is bolted onto the throttle housing (manifold) remove air filter and at rear of throttle housing you will see 2 x multiplugs (release by swinging clips 90 degrees) these plug into ecu (4 bolts) Unfortunately new or replacement ECU,s need reprogramming. Although if changing an engine over you must swap Ecu and keep original or key won,t identify code.
Where can you find an ECU replacement for a 1986 Honda Civic Si?
At any auto parts store or auto salvage yard. The ECU is also called a PCM. The computer of the vehicle.
Do you need to reprogram your ecu when adding a turbocharger?
yes i want to reprogram my ECU of my bike
How do you wire in a two socket tow bar to a Peugeot 407 SW LOOM?
You need a peugeot kit, that includes a new ECU. This then needs coding into the vehicles BSI, which can only be done by a dealer.
How do you program your replacement ecu for your 91 firebird?
if you installed a new ECU. you install your old mem cal eprom the best way is to desolder the factory eprom solder in a zif socket purchase atmel 29c256 eeprom. you would need software such as tuner cat to change parameters you would need a eeprom programer such as pocket programer and write in .bin
How do you replace the ecu on 2006 Toyota corolla le?
Take it to a dealer and they will do it free, under a recall issued by Toyota for possible bad ECU in 2006 and other years, Recall ID# 81878
1995 peugeot 106 1.0ltr which has broken down.the garage have told me the ecu is nackered.what could have caused it is it cheap or easy to repair yourself and will a 2nd hand ecu plug straight in?
Try the ECU doctor, (google the site) a lot of ecu's are programed to the vehicle, I was quoted £800 to replace one by dealer, ECU doctor repaired mine and gave 1 year gt
