It depends on which sensor you're working on (front or rear, and which engine size V6 or V8). It could be either the standard threaded type with the 7/8" hex, or the type with a flange that is held in place with bolts/nuts. If the sensor you're working on is the standard type without a flange, you can use an open-end 7/8" wrench if you have room. If not, there are special oxygen sensor sockets (with a slit at the side so the wires don't get pinched) you can use with an extension and ratchet. For the flange type sensors, all you would need is a socket (probably 12mm)or an open-end wrench if there's enough clearance.
kick it out
how do you change the fan belt on 2003 Toyota Tundra 4.7 liters?
It is illegal to remove the catalytic converter from any vehicle.
idk go ask the dealer ship
No It is illegal, It will harm the economy, and performance of the car
i have a 2004 Toyota tundra double cab i want to remove passenger door panel to tight door handle
You can turn off the low tire light, on your 2005 Toyota tundra, by holding in the reset button. You can also remove the fuse for 10 seconds and replace it to its original slot.
there is no dip stick. you have to remove bolt from the side of the transmission
please tell me how to reset the computer on a 2008 5.7 Toyota tundra. all my dash lights are on. thanks, Patrick ANSWER: all you have to do is remove the positive terminal on your battery and that should work. but be carefull while doing this as you should remove the ground first to prevent shocking/shorting.
Changing the spark plugs on a tundra you remove the cover over the plug then carefully remove the plug. Make sure that you only do one at a time so as not to mess up the firing order. Hope this is helpful.
I own both a 2008 tundra and a 2003 4Runner. Both of them have a cabin filter behind the glove box. Remove the glove box door and you will find it.
remove intake assy and its inside the engine block,you can see once you remove the intake.its bank 1 aND BANK 2