0
Do you need special tools to remove the crankshaft damper pulley on a 1998 Monte Carlo?
Wiki User
∙ 15y ago
you just need a puller to take it off, it's not a special puller.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Do you need special tools to remove the crankshaft damper pulley on a 1996 Mitsubishi Eclipse?
on the Chrysler engine (420a) you do need a puller and installer to deal with the crankshaft dampener pulley.
How do remove a 1996 Chrysler damper pulley?
Depending on engine displacement in general remove belt-s then bolt holding pulley to the crankshaft then using a puller remove the pulley, when installing use a installer not a hammer to put the pulley on the crankshaft.
What puller is used to remove crankshaft pulley?
Depends on what type of vibration damper (crankshaft pulley) you have. Your local auto parts store probably has the one you need and can rent it to you.
How do you replace the crankshaft pulley on a 1991 Chevy S-10 4.3L?
Disconnect the battery and remove the fan assembly and crankshaft belts. Remove the center bolt from the pulley and use a crankshaft pulley remover to pull off the pulley. You can usually borrow one from an auto parts store.
Where is the crankshaft sensor located on a 1993 Chevy Lumina Z34?
You'll need to pull the passenger front wheel, remove the wheel well cover. This will expose the damper pulley on the crankshaft. Remove damper pulley, remove plastic engine cover. Look inside you will see the sensor. Be sure if you replace it to install the new one exactly the same as the old one was.
How do you replace crankshaft sensor on 2001 s10 blazer?
Locate the crank sensor behind the vibration damper (crankshaft pulley). Unplug the wire harness connected to it. Remove the small bolt holding the sensor in place. Remove the sensor.
How do you change Aerostar harmonic balancer?
Start by disconnecting the negative battery cable at the battery. Remove the radiator. Remove the drive belts and crankshaft pulley. Remove the Vibration Damper (Harmonic Balancer) bolt. Use a puller and remove the Vibration Damper. Reverse these instructions to reassemble. (Tighten the Vibration Damper bolt to the correct torque)
How do you remove crankshaft pulley without special tool?
put the car in drive and crankshaft wont turn anymore. then you can take off the bolt
How do you remove the crankshaft pulley on a 1997 dodge neon?
You need to remove the bolt, insert the special tool in the hole, and install a three jaw puller to pull the pulley off.
How do you remove damper pulley on 91 Saturn SL?
Just remove the bolt holding it on.
What tools do you need to remove the crankshaft pulley pn 1995 Honda Passport?
What tools do you need to remove the crankshaft pulley on a 1995 Honda Passport?
How do you repair a crankshaft pulley for a 98 Saturn SC2 DOHC?
u need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removalAnsweru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal Answeru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal
