0
No, it should be internally lubricated so there is no need to lubricate the starter.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Do you need to oil or grease a new starter motor?
No they do not require you mess with them when new.
Do you need to fill the fuel pump before installing?
No.
Factors to consider before installing operating system?
Before installing an operating system, you need to consider how big you hard drive is. You also need to consider what types of programs you will be using.
What could be wrong if after installing a new battery and alternator truck still wont start or run?
It could be the starter in it. It may be weak or need replaced.
Do you need a waterproof membrane before installing tile in a bathroom?
Don't HAVE to, but it is a good idea.
Do you need sims2 before installing other sims?
if you mean expansion packs yes
Do you need sims 2 before installing sims 3?
umm..i don't think you will need to install sims 2 before installign sims 3.
Do you need to unhook the battery before installing the new radio in your lanos?
Yes, most definitely.
How do you replace the starter on a 1999 Monte Carlo?
Replacing the starter on a 1999 Monte Carlo is fairly easy to do. The car will need to be jacked up to reach the starter. The wires will need to be disconnected from the starter before removing it. After the wires are removed, the starter can be taken down by removing the two bolts. After the starter is removed, replace it with a new one.
How do you replace a polaris sportsman 450 starter motor does the clutch need to be removed?
clutch doesn't need to be removed. disconnect battery, remove hot electrical wire. remove 2 10 mm bolts and remove starter. might have to tap it to loosen up. reassemble. if necessary sand hole where starter goes into housing and coat with grease. tap if necessary.
If the starter is causing a 1993 Geo Metro to only stat when it is push started in second gear where is the starter located and how do you repair it?
The starter on a 93 Geo Metro is located on the back side or firewall side of the engine. The battery will need to be disconnected and the cables removed from the solenoid and then the two bolts holding the starter to the engine can be removed. When installing the starter make the battery connection the last thing you do.
Must you uninstall Quicktime before installing Quicktime 7.6?
There is no need to uninstall an older version of QuickTime before updating to QT 7.6.
