13 ounces
as recommended by the manufacturer
22psi
Remove bolts at top of suspension forks. Raise front wheel off ground. Pour oil into top of front forks. Leave 100 mm or 10 cm measured from top of forks.
You need three things for something to burn, a fuel (the oil), an ignition source (the burning oil), and oxygen (air). When you put the blanket over the pan, you eliminate the air from the equation, thus extinguishing the flames.
Most are shipped unoiled, and will need a few drops of oil. Check the instructions on the package.
The best way to replace fork oil in these forks is to measure the oil level with fork springs removed, fill the forks with aprox 350cc's, pump the forks a few times to fill the damper and anti-dive valves at the bottom, then compress the forks (without springs) and measure about 5.5" to 6" inches from the top of the tube to the top of the oil level INSIDE the fork. You should only have to add another 50cc. Total about 400cc's. Extend the fork, replace the springs and caps. The forks should have enough oil to work properly, and not hydraulic lock from too much oil. (If you have put too much oil in, the forks will feel like they bottom before using all the travel.) mike
first you have to put the vehicle in the air. Then you need to remove the oil drain plug to drain out the oil and then remove the filter and unbolt the pan.
No, not on a normal air filter. But if it is an oil filter yes you apply oil to the filter.
People put their forks on backwards because it is a lot easier to do foot jams, you have more of an area to put your foot... -Steiner
Try to put oil into fork and knives and try to hold it. The state of the forks and knives covered in oil is called reduced friction. 0 friction means there is nothing, no force to stop the fork and the knives from falling off your hand and sliding through any object. Therefore, you need friction in order to grab and forks and knives and hold onto it.
what kind of hyderlic oil i have to put in jack