0
Do you need to remove the drive shaft to change the starter motor on a peugeot 307?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What mileage to change drive belt in peugeot 206?
The drive belt on a Peugeot 206 should be change in 80,000 miles. Failure to change drive belts at the appropriate time can result in expensive engine failure.
How do you repair the starter drive on a 1991 4x4 5.7L GMC 12 ton truck?
Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft
Alternator drive belt installation and tension on peugeot partner diesel van with power steering but no Air con?
The tension of a drive belt on a Peugeot Partner Diesel Van can be determined by using a tension gauge, which can be used to measure and adjust the beltÃ?s tension. To replace the belt, open the hood, remove the screws to the air filter cover, and then remove the filter. Next you will need to remove the engine cover and begin to remove the starter. You will need to have the vehicle raised to gain access to the belt and may need to remove other parts to get a clear reach.
How do you remove a starter out of a 4.3 Chevy s-10 with a manual trans and 4 wheel drive?
You will need to loosen the motor mount on the side of the starter to jack up the motor slightly to remove the starter after removing the bolts that hold the starter on to the engine. Remove all wires from starter also.
Where is the Starter Drive Gear Located on a 1994 Pontiac Grand Prix?
At the end of the starter motor shaft. Remove the starter and look in the opening that faced the transmission and you will see the gear.
How do you take the starter out?
Drop the dust cover. Drop the drive line take bolts out and there ya have it! It is difficult to remove the starter on a Blazer. Disconnect battery (negative), disconnect 2 wires on starter, remove 2 bolts - it drops down but you must still remove a cross member to remove it from the car
How do you change the starter in a 1998 Sentra?
This is how I did it. Disconnect the battery negative terminal. I removed the right drive shaft. This made it possible to reach the starter from under the vehicle. Then I removed the brace that bolts to the block and intake manifold. Then remove the electrical connections on the starter, one with a 12mm wrench from under the car, the other is a plug you can reach from the top (if your arm is skinny enough!). Then remove the starter top bolt from above. It threads into the starter from the transmission side. Then, from under the car, remove the starter bottom bolt. The starter can then be removed from under the car. As many a repair manual has advised: "Assemble in reverse order of removal." Good luck!
How do you change the starter on a 1995 Oldsmobile Aurora?
Hey Deborah==Remove the neg battery cable then the wires on the solonoid. Then take out the 2 bolts that hold it on. goodluckJoe Disconnoct the negative battery terminal. After the car is up on appropriate support so one can work under it, the four bolts, 10MM, that hold the torque converter cover on must be remover and the cover removed. Then, put blocking or a small hydraulic floor jack under the starter and remove the front bolt that holds the heat shield to the starter. Then remove the two bolts,15MM, on the gear end of the motor. Slowly lower the starter down until the wiring can be removed. Be careful the stud(s) stays in place when the nut is removed. (Also when re-installing the new starter). Reverse the process to install the new starter.
How do you change a Fiat Doblo drive shaft?
how to remove a drive shaft on a fiat doblo
How do you replace the starter in a 1999 Chevy Blazer?
on a 2002 4 wh drive Blazer - disconnect the battery - lossen starter bolts ( 2 ) loosen and remove the Flywheel plate that the Starter is inserted into or you wont be able to pull the starter out - really tight space 2 bolts to remove this plate - plate has an opening that the starter goes into to engage the flywheel
How do you replace the starter on a 1995 Buick Regal limited with the front wheel drive V6 3800 series II engine?
Disconnect - battery cable Raise and safely support vehicle Remove starter mounting bolts Remove wiring harness Twist and drop starter
Where is front abs sensor peugeot 406 2000?
ring on drive shaft with senser next to it. usual fault! cracked by rust ring on drive shaft. change shaft.
