answersLogoWhite

0

Hey Deborah==Remove the neg battery cable then the wires on the solonoid. Then take out the 2 bolts that hold it on. goodluckJoe

Disconnoct the negative battery terminal. After the car is up on appropriate support so one can work under it, the four bolts, 10MM, that hold the torque converter cover on must be remover and the cover removed. Then, put blocking or a small hydraulic floor jack under the starter and remove the front bolt that holds the heat shield to the starter. Then remove the two bolts,15MM, on the gear end of the motor. Slowly lower the starter down until the wiring can be removed. Be careful the stud(s) stays in place when the nut is removed. (Also when re-installing the new starter). Reverse the process to install the new starter.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you change a starter in a 1995 Aurora?

on the 1995 aurora to change out the starter the top end has to be pulled the starter is internal it is located on the drivers side of the engine


When was Oldsmobile Aurora created?

Oldsmobile Aurora was created in 1995.


What is the car of the year 1995?

Oldsmobile aurora


Is there a gasket on the intake manifold for 1995 aurora olds?

i am replacing the starter on olds 1995 aurora


Fuel reset button on 1995 Oldsmobile aurora?

Does not have one.


Where is the horn located under the hood in the Oldsmobile aurora?

In the 2001 Oldsmobile Aurora, the horn is located under the left headlamp on the left front corner of the car. The Oldsmobile Aurora midsize sedan that was launched in 1995.


What is the Engine oil Capacity for a 1995 Oldsmobile Aurora?

7.5 QTS.


Where is the blower in a 1995 Oldsmobile Aurora?

under dash on passenger side


Where is the starter solenoid and starter relay on a 1995 Oldsmobile Cutlass Supreme?

There is no relay. The solonoid is on the starter.


Where is the cabin air filter on a 2000 Oldsmobile aurora?

Oldsmobile did not build an Aurora in 2000. Is your car a first generation 1995 to 1999, or is it a second generation 2001 to 2003.


How do you change the starter on a 1995 Oldsmobile Cutlass Ciera?

To change the starter on a 1995 Oldsmobile Cutlass Ciera, first disconnect the negative battery cable to ensure safety. Then, locate the starter, which is typically mounted on the lower side of the engine near the transmission. Remove the electrical connections and the mounting bolts securing the starter in place. Finally, install the new starter by reversing the steps, ensuring all connections are secure before reconnecting the battery.


Where is the windshield fluid pump located on a 1995 Oldsmobile aurora?

It is under the squirt bottle.