Chevy Lumina
Air Filters and Intake Manifolds
Late Model 1979-New Ford Mustangs

Do you need to remove the throttle boddie to replace the themostat on a 97 Chevy lumina?

282930

Top Answer
User Avatar
Wiki User
2006-01-11 06:04:14
2006-01-11 06:04:14

I don't think so. Follow the upper radiator hose to where it connects to the motor. There's a bubble-like metal piece there called the thermostat housing. It connects to the engine with 2 bolts. Removed what you have to to get to this housing.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

What sensor?? most are held on with screws..

User Avatar

It is on the throttle plate opposite of the bellcrank.

User Avatar

The Throttle Position Sensor is located on the throttle body on the opposite side of the accelerator cables.

User Avatar

its on the throttle body just above the throttle position sensor (t.p.s)

User Avatar

It is very possible that the throttle plate is dirty and causing the throttle to hang up.

User Avatar

How do you replace the blower motor on a 1994 chevy lumina euro?

User Avatar

Follow the upper radiator hose to the engine block. The part the hose is connected to is the thermostat housing. The thermostat is under it.

User Avatar

Goto figure 11 Link. Shows a picture for 3.1L after 1993 from Autozone You also have to deal with a throttle cable housing right above it.

User Avatar

Its located under the throttle body or follow the upper radiator hose til it hits a semi round housing. There is 2 bolts to remove it. First you have to drain the radiator fluid of course. I am changing the thermostat right now on my 2001 Chevy lumina and I see I will have to also remove the throttle body to get to the thermostat housing

User Avatar

how do u replace the starter on a 95 chev lumina?

User Avatar

i wnt to know how to dis-assemble a transmission in a 1996 chevy lumina

User Avatar

I have had to change it 2, and it is a royal pain in the butt. There are two bolts holding the housing on, however the housing is located underneath the throttle plate. so that being you have to remove the throttle plate and even then its a pain in the butt to get to the housing bolts.

User Avatar

If you look at the throttle body see where the accerlator cable hook up is . it should be on the oppset side.

User Avatar

The front dash holder in the 1999 Lumina is screwed into the backside of the dash. Go through the glovebox to loosen the screws to replace.

User Avatar

To replace a turn signal switch in a 1993 Chevy Lumina go to the trunk of the vehicle and find the plastic covering for the turn signal. Remove the cover and replace the bulb.

User Avatar

remove bolts and replace it how do u think

User Avatar

To replace timing chain on a 3.1 Chevy Lumina engine, you need to first make sure that your motor or engine is turned off. Then you need to remove the chain and replace it.

User Avatar

What is the avearage cost to fix a blow headgasket on a 98 lumina

User Avatar

replace a windshield wiper switch on a 1995 chevy lumina van

User Avatar

Follow the air intake hose to the throttle body. Mounted to the "front" of the throttle body are two sensors. The upper is the idle air control valve. Under this one...and a little difficult to get to is the TPS.

User Avatar

Ask someone who knows about a 1991 Lumina 3.1 Euro or 'google' it!

User Avatar

The throttle idle sensor is located on the side of the throttle body. As a result of its location, it is important to make sure that you watch where you put your hands so as not to trip it.

User Avatar

It's under the throttle body housing. I'm looking for an answer on how to take the housing off to get to the thermostat

User Avatar

its easy it a sensor between the air filter housing and the throttle body with a wire harness connector on it. It shold be attached by 2 little torques head (kind of looks like a star) screws


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.