0
Do you need to reset the computer after installing a new cam sensor?
Wiki User
∙ 15y ago
usally you do . if it doesnt work restart your computer,
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Will the o2 sensor reset it self in a 96 ford explorer if you change it or do you have to do it with the computer?
there is no need to reset the computer for an 02 sensor.
Does a 98 expedition Oxygen sensor need codes when replaced?
Just reset your computer after replacing the O2 sensor.
How do you reset the o2 sensor on an 2001 Chevy Prism?
There isn't a reset for the oxygen sensors. When a repair is made then you need to have the computer cleared.jd
Do i need to reset my computer after installing a cold air intake for my kia rio 06?
Short answer is no. When the car warms up after installing the intake, take it for a drive, the mass air flow sensor will tell the computer there's more air and the computer will automatically adjust. If you reset the computer, the calibrations from all the sensors is lost and must be relearned. On some vehicles, during the relearning process, the engine may run rough and the transmission may shift harder or slip until the drive cycle is complete. Save the headache, the computer should take care of everything.
Do you need to reprogram computer when replacing cam sensor on a 1988 BMW 535is?
no you don't need to reset the computer. but it is always a good idea to reset it when replacing any censors. just unhook the battery cable( negative) for 30 seconds then put it back on and drive 50-75 miles to reset the computer.
How do you reset computer after replacing oxygen sensor on 1996 GMC Safari?
The computer will reset itself after a few driving cycles. To reset the Check Engine light you can try this. Disconnect the positive battery cable for 20 minutes. If that does not work you will need an OBD2 scan tool to reset the light. Go to the place where you bought the O2 sensor and ask them to reset the light. Some will and some won't.
How can you reset the air bag sensor 2006 jeep commander?
There is no "reset". If the light is on, the computer has detected a malfunction and set a code. The cause will need repaired, and the light will clear itself.There is no "reset". If the light is on, the computer has detected a malfunction and set a code. The cause will need repaired, and the light will clear itself.
How do you reset power train computer after replacing oxygen sensor in 2002 Lincoln LS?
Why would you need to reset the Powertrain control module (PCM)???Are you asking how do you clear the CHECK ENGINE LIGHT??
When Ireplaced cam shaft position sensor the light stayed on and the computer says that it is still that sensor?
you need to do a system reset. push the setup button on your dash a couple times until it gives the option to reset. then hold the reset button for 3 sec. hope this helps. Have you cleared the original codes?
How do you reset computer on 2003 Tahoe after replacing knock sensor?
You need an OBD-II code reader. Some parts stores can do it for free if you do not have this tool.
What is wrong when you rear abs and brake light sensor stays on in your 1995 rodeo?
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
Do you need to reset the computer if you change batteries?
No, all you need to reset is the clock and radio presets.
