yes you remove a Nissan 200sx motor from the top. unless you want to drop it down through the engine compartment using a lift. its much easier to pull the motor off the top of the transmission than to take it all out the bottom. its even easier to replace a clucth by pulling the motor thatn pulling the trannie.
follow top rad hose into engine remove the 3 bolt housing and ul see it
from the top just dismantle all the wiring,engine mountings and round bolts then be sure while removing if there any undismanteled parts.
You will have to remove the engine.
no u do not
For the 1988 1.6 and for most cars, follow the top radiator hose from the radiator to the engine block. Remove the hose from the engine block then remove the flange the hose was connected to (usually 2 bolts but may be 3 bolts on the Nissan). The thermostat is behind the flange.
you can remove the engine from the top by leaving transmission still in car
can a starter be removed from the top on a 98 Nissan sentra gxe
You remove and install the engine from the top.
If you stand facing the engine with the hood open. The alternator is located on the left side of the engine. It will be difficult to see from the top. But can be seen if you remove the plastic cover on the right front wheel well, or if you were to remove the plastic panel underneath the car.
The Nissan largo top up point is just to the left of the gear stick. You will have to remove the central console to do this.
how do you remove the engine? Is it pulled from the top or do you unbolt the sub frame and slide it out from under the car?
Either remove the engine or remove the transmission, take your pick.
should eather be at the top in to engine or on bottom hose coming from engine
The thermostat is located inside of the top water hose inlet. Remove the top hose, then the inlet to remove the thermostat.
from the top
remove the cover on top of the engine. the wies are om the igniter coils remove the cover on top of the engine. the wies are om the igniter coils
remove neg.cable.then positive cable cable from starter,remove male to female wire ,then remove 2 bolts holding starter to engine.
by going over the top of the bell housing
Th knock sensor on a 2002 Nissan Xterra 3.3 is located on the top of the engine. It is mounted under the engine intake.
Basically 1 Hang the engine from a bracket that runs over the top of the engine bay 2 Remove the rear tires, and brakes 3 Remove the two rear axle shafts 4 Remove the engine cradle, with the engine supported by the top bracket 5 Remove the transmission that is hanging with the engine 6 Remove the pressure plate, and clutch, and flywheel from the hanging engine Installation is the reverse of the above
The oil filter is located at the bottom of the engine. It can be remove with an oil filter wrench. Do not remove the engine top cover unless you need to repair something very major.
It is easiest removed from the top.
You will find the thermostat on the passengers side of the engine where the top radiator hose goes into the engine.