no... you should call a professional to come inspect your pool
You will see small amounts in the site glass when back washing the filter. k
Definately after each vacuuming, and i would say when first getting started in the summer if you leave your water in all winter backwash after the first 8 hours ur pump has been running.
Filter, winter, closed, backwash, rinse, waste
Your sand filter multihead is either in the backwash, rinse, or waste position. Move it to the filtration position.
I have a backwash setting on my sand filter. You can also add a sand cleaner in the bottom skimmer of the pump. After backwashing, it is recommended that you also rinse the head.
The rinse cycle clears the cloudy water out of the system after bacwashing.
Because dirt and small sand will pass through the filter the first time it is run after backwashing. By rinsing you are sending that debris, which could cloud your pool, out of the backwash port instead of back into the pool.
There wont be any dirt under the sand. When you vacuum your pool you should do it on filter mode Otherwise you will lose a lot of water for nothing, this would be especially wasteful in the case of a salt water pool. Ofter having vacuumed the pool on filter mode and if the pressure gets too high backwash. after backwash rinse for a minute, then return to filter.
"BACKWASH" THEN RINSE THEN FILTER.K
Nope, Just as long as you turn your dial to backwash , waste and then rinse, You shouldn't have a problem. Watson's told me the filter sand should be good until 7 or so years. Until you cannot see any sand in the glass part on your filter, you should have it replaced.
Empty the skimmer baskets and the basket that's attached to the pump. Then backwash and rinse the filter.
Depending on the size of the pool and the size of the filter and the amount of times you have to backwash, also if you have had a lot of rain then you may need to backwash more than usual. If you put the pool in and the filter and you know how old the sand is, if you are backwashing more than usual,change the sand. Also before you backwash check the pressure of the water going back into the pool, then backwash check the pressure again the pressure should for any size hayward pump push your hand away if it does not then change your sand.
You should never rinse more than a couple of minutes. Rinse is the last stage of Backwash. After rinsing a minute or two the multighead should be returned to filtration.
Backwashing is done to clean the filter media in sand and DE systems. Cartridge filter systems don't have a "backwash" provision. You just remove the cartridges and wash off the dirt and debris with a hose.