Unscrew (Try it and see!)
It is hard to imagine any car/vehicle engine that has push-in pull-out spark plugs! The pressure from the burning/exploding fuel would pop them all out as soon as the engine started!
Remove the plug wires by turning them on the plugs to break the seal then pull then off and unscrew the plugs and regap the new ones and reinstall them
When changing the spark plugs on a 2006 Toyota Tacoma make sure the vehicle is off. Use a spark plug socket and pull the spark plug wires. Remove the old spark plugs and properly space and install the new parts.
pull the old spark plugs out and put the new ones in dumbazz pull the old spark plugs out and put the new ones in dumbazz
Pull on the boot.
They are in the head and some have a removeable cover. GoodluckJoe basically, if you lift the hood and look directly at the engine (the big silver thing), on the top left side of it as you are looking at it from the front is where you place the oil in (oil cap). Just above that are the four spark plugs. They are underneath the plug and coils. you would have to unscrew the two bolts holding the coils down to get to two of the spark plugs, and the other two spark plugs, you just pull the wires off. (Just pull)
look on the very top of the motor and you will see a long rail them are the spark injectors for your spark plugs. pull them injectors out and you will see your spark plugs.
pull the wire cap off, unscrew with the right size socket and replace with new sparplug, then push plug wire back on and your done.
Change one at a time. Pull out the ignition lead and then get a 10mm spark plug socket. Unscrew and then screw in the plug fingertight. When its finger tight, tighten 1/2 a turn. Push the ignition lead back in and repeat on the rest of the plugs.
They are easy to find. Follow the spark plug wires down and pull of the spark plug boot. The plugs are right there.
spark plug socket extention and rachet pull boots off plugs and have at it
Pull wire off the spark plug
to change the spark plugs first take off the plastic cover on top of the motor, the spark plugs are on the center of motor you see two coils on top of the two center spark plugs and two spark plugs wires going to the out side spark plugs you pull the wires off and you need a long socket wrench or a spark plug socket with extension bar to take it off, also you need to pull the coils to replace the center spark plugs they are under the coils. NOTE. this is for a four cylinder engine. excuse my English B. Cerda.