answersLogoWhite

0


Best Answer

The fuel pressure is WAAAY too high 35 psi is about what it should be at. New fuel pump is needed. That should be your solution.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Dodge Ram 1500 5.9 gas jumps when it goes in 3rd or overdrive fuel pump pressure is 50 psi what is the problem?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Oil pressure gauge reads zero after starting the engine then in a couple of minutes goes up a little then jumps to normal and stays there?

Oil pressure has to built up. As long as the pressure is normal and the oil level is good. There is no problem.


Is the Dodge Dynasty 1991 v6 3.0 liter engine have a non interference engine?

It is supposed to be a ZERO interference motor. If belt breaks or jumps, NO problem to valves in most cases.


40 to 45 van shakes and jumps when overdrive is put on it stops?

Have the Transmission serviced (Filter and Fluid Change) - Should take care of it.


What is wrong when a 2000 dodge neon 5 speed jumps out of fifth gear while driving?

Possibly bad synchronizer.


How many jumps on a trampoline do you have to do to lose a stone?

If you mean a kidney-stone then there is no fixed amount of jumps to pass a stone ; you may very well exacerbate the problem - seek professional medical advice .


How do you know when motor mounts in a 2002 dodge neon needs replacement?

If your engine jumps when accelerating, or when certain noises are made when engine torques.


Why does your car jumps when shifting from park to drive?

The most common problem I have seen is a failed motor or trans mount.


What could be the problem with a 1999 Tahoe that jumps when accelerating with an automatic transmission and what is the cost for fixiing this problem?

I had mine rebuilt for around $1,700 using non OEM parts.


What's up your oil gauge go's up and down no matter what rpm's you am at?

Sounds like a wiring or sender unit problem. Ground wire at sender unit, see if it stays steady. If it still jumps around, wiring/gauge problem. If it stays steady, sender unit should be replaced. Good idea to do an oil pressure test as well.


Why is jumps called jumps?

*Why are jumps called jumps?In order to clear an "obstacle" of any sort, a horse must jump over it. Therefore these "obstacles" became known as jumps.


How do you beat the eagle on sonic rush?

When he jumps to the side, he will either start to blow you away or start to jump at you. As soon as jumps at you, he will try to peck you. Dodge him but make sure he is still close. After that, jump on him and he will get hit. Another way to hit him is to waituntil he stops shooting at you and pauses for a while, then he will try to peck at you on the side of the pillar. after he tries to peck at you, dodge it quick and then hurry and attack him. repeat both of these prossess's until you defeat him.


How to pop the bubble over bowser on princess peach?

if you mean on New super Mario bros, you just dodge the balls of fire then when he jumps really high run under him