answersLogoWhite

0


Best Answer

If your engine jumps when accelerating, or when certain noises are made when engine torques.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you know when motor mounts in a 2002 dodge neon needs replacement?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much motor oil does a dodge neon needs?

4.5 quarts


What causes heavy vibration at high speed?

Could be motor mounts, the tires out of alignment or out of balance, or the steering needs work.


Why do your 1999 mercury villager motor mounts in front keep braking and why does it have a three second delay after putting vehicle in drive?

The motor mounts should not keep breaking if they are installed properly. The delay in the transmission indicates it needs work, probably a rebuild.


How do you tell if motor is bad?

The motor needs to be diagnosed to find the exact problem . If the cost of repairs is more than a replacement, then the motor is deemed bad.


Honda Pilot motor mount replacement?

First thing you must do is find the motor mount that needs to be replaced as there will be three of them on there. Once you have found the problem motor mount you must loosen up the other mounts so that the motor will move a little. Now using a jack raise the motor up far enough to get the broke mount out and replace it with the new one. retighten the remaining bolts and finish up.


Why wont my 306 cabriolet roof go down there is no motor noise?

It probably needs a replacement motor or one of the roof mechanisms have failed.


Can your motor fall out if the mount needs to be replace?

While it is possible for an engine to fall out if the motor mounts are bad, it is very unlikely. However, a broken mount will likely destroy the engine if it is not replaced.


2000 Camry's engine shaking when car is stopped and transmission is in drive position?

Bad motor mounts and needs a tune up probably


Why does Fan only works on hi 1998 dodge caravan?

Because it needs a new blower motor resistor.


What needs to be changed when installing a 1990 fuel injected Chevy 350 engine into a 1986 Pontiac Parisienne that has a fuel injected V6?

The bellhousing, the starter, the exhaust manifords, maybe the flexplate (flywheel) and the computer, and probably the motor mounts. I'm not sure if the V6 crossmember that the motor mounts bolt to will have to be changed or not. I guess it might.


Why is it difficult to out of park on a 98 Camaro automatic transmission?

EITHER NEEDS LINKAGE ADJUSTMENT OR TRANSMISSION OR MOTOR MOUNTS COLD HAVE SHIFTED.or wrecked.Or THE DETENT in the trans is sticking


Ford Focus mk2 engine vibrates?

Excessive engine vibration can because by and engine that needs to be tuned up. The vibration can also because by worn out motor mounts.