0
It has many more that 2. But, if you are referring to O2 sensors then it has 1.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is the camshaft sensor on a 1989 olds ciera 2.8L?
There isn't one on that engine. Only a crankshaft sensor at the back of the engine.
How do you replace a throttle position sensor on a 1989 cutlass ciera?
Unplug the wire on the side,remove the screw on it,,pull it off and replace with new one.
Can doors from a 1990 Olds Cutlass Ciera sedan be used to replace the doors on a 1990 Olds Cutlass Ciera station wagon?
yes, most of the panels can be used from one to the other
Which of the three relays on the left front of a 1993 Olds Cutlass Ciera is the AC fan relay?
I have a 1993 olds cutlass ciera and the AC fan relay is the one in the middle on my car.
What is floor leak front drivers side on 1989 Olds Cutlass Ciera brake fluid or coolant?
This is an easy one... Is the fluid green? if it is, it's coolant.. if not, its brake fluid.
How to replace idler pulley on 1992 Olds Cutlass Ciera?
take off the belt and there is one bolt take it off and put a new one one.
What sensors are needed to be changed out from 95 ciera model three one L v6 engine to match back the original 95 supreme three one L v6 engine so the original engine harness fits the ciera engine?
Sensors needed to be changed out from 95 ciera model three one L V6 engine to match back the original 95 supereme three L6 engine are Ciera Knock Sensor and Soeedometer Sensor.
How do you fix the oxygen sensor in Bank 1 sensor 2 of a 2002 Olds Alero?
Replace it. Sensor 2 is the one AFTER the catalytic converter.
What body parts on a 1993 Cutlass Ciera will interchange with other GM cars?
The body was basically the same on the Ciera from 1989-1996, so any parts from one of those years should work
Where is the cam sensor for a 1990 Oldsmobile cutlass ciera?
i have a 90 cutlass ciera with a v6 3300 and just replased that. it is called a combanation sensor. its the crankshaft and cam together located at the back of the harmonic balancer attached to the block. it has 2 bolts on the right side holding it to the block a one in the middle to hold the sensor in place and the sensor sits in it and faces the harmonic balancer on the back of the interrupter rings
What do you do to change the bank1 sensor 1 on a 1997 olds bravada?
You take the old one off, and install the new one.
How do I locate and replace the crankshaft sensor on a 1996 Olds Ciera V6 3.1L?
Remove the belt.Take out the 3 bolts holding in the power steering pump and lay it aside.The sensor is right there being held in by one bolt.Remove the bolt and pull the sensor out.Becarefull not to twist or angle it as it comes out if its a bit tight.Trust me,you don't want this to break off and the piece fall off in the block.Replace the sensor and remount the steering pump and the belt and you should be good to go!The code in the PCM should reset itself after about 100 miles or so.
