One battery is sufficient if it has enough capacity. You will not succeed in pull starting that truck because the fuel shut off solenoid only activates (turns the fuel on) when the starter is engaged.
If yo have power to both wires at the starter when trying to crank, the starter is failed.
It is in the side of the block behind the starter.
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
Front driver side of the crankshaft pulley.
YesYes
All that is required to restart a 2006 Cummins is to add fuel and crank the engine. The fuel system is self bleeding.
yes gap it at .50 with brass gauge.
It sits behind the starter on the drivers side of the engine. You will have to remove the starter in order to see it.
The 2003 is self bleeding. All you have to do is crank until it starts. If it is not starting then the lift pump is bad, or there is a leak in the supply line.
The common rail systems made by Bosch and used on the Cummins engines in Dodge trucks and in the Mercedes/Dodge Sprinters are self bleeding. All you do is crank the engine and it will purge the air on its own.
The fuel system on a 2008 Cummins is self priming. Just turn the key on and crank.The fuel system on a 2008 Cummins is self priming. Just turn the key on and crank.
It is on the drivers side buried behind the starter. You need to remove the starter and then you have access to it.