Your 3.0 Ford Taurus has a timing chain and is non-interference. No scheduled replacement is necessary. The only 3.0 Ford Taurus that had a belt was the SHO model, which had a Yamaha built 3.0 V6. I think it may have been a mistype, but the motor IS and interference motor, which is why you need to be careful. However, there is no belt, so if you are not messing with the chain then you will be fine because unless there is a problem with a tensioner, guide or the actual chain, your engine will not jump time. If it does, however, you will be bending valves or notching pistons.
it is an interference engine, so get you timing belt changed
It has an interference engine. Get that timing belt replaced and do the water pump at the same time.
ITs interference
The instruction of timing belt kit from Continental says that it is interference, so I wouldn't take a risk
interference engine--don't let the timing belt break, or you will incur serious engine damage! also, better replace the water pump at the same time you replace the timing belt.
The 3.0 liter V6 in a 1998 Toyota Sienna is a NON INTERFERENCE engine according to the Gates website ( they make timing belts etc. )
The 2.5 liter 4 cylinder engine in a 2000 Subaru Outback is an interference engine ( according to Gates , they make timing belts etc. )
Interference, so make sure you replace the timing belt and the water pump, otherwise you'll do some serious damage.
On an interference engine you can have internal engine damage when you attempt to start it. On a noninterference engine it may not start or it may backfire, or miss, if it does start.
It's a interference engine best change the timing belt + water pump around every 60,000 miles you notice the engine slip when you drive. The 1.8 litre quad cam engine is "non-interference" Fact! The 2.0 litre is interference. And yes you should change your timing belts to prevent breakage
If the engine is an interference type serious engine damage will result. If engine is noninterference type it will just stop.
Only the 1999 Ford Taurus SHO has a timing belt. The engine is built by Yamaha and NO it is not an interference engine. Replace the belt at 100,000 miles. All other Ford Taurus's have timing chains.