0
According to www.motorcraft.com - YES !
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you locate the door sensor that controls the overhead light in the cab of a 1998 Ford Ranger?
The sensor is intergrated into the door latch. If it is not working (and the door chime stays on) spray it with WD 40. This almost always works.
What symptoms does a 2003 5.4 liter expediton have when the dpfe sensor goes bad?
One symptom of a 2003 5.4 liter Expedition when the DPFE sensor goes bad is the engine light stays on constantly. Another symptom is exhaust back pressure causing the vehicle to chug slower at speeds of 35 to 40 mph.
98 marquis surges from 40-50 mph why?
it could be the DPFE sensor that's what was causing my 02 to surge like that i was told that is a common sensor to go bad. it cost about 75 dollars and took me about 5 min. to replace.
How much does a brake calliper cost for a 1986 Ford Ranger?
A brake calliper for a 1986 Ford Ranger would be likely to cost between $20 and $40, depending on where you source it.
How do you replace the DPFE sensor on a 2001 Ford Escape?
3.0L Escape DPFEMy girlfriend's 2002 Escape just had this issue. It was throwing a P0401 EGR Flow Insufficient code at about 40 mph. Hers is a 3.0L V-6, hopefully yours is as well. The sensor is on the EGR tube from the exhaust manifold to the intake. There are 2 parallel smaller tubes that rise vertically from it, directly in line from the throttle body to the firewall. At the top of that is a little black box with 2 hose nipples on the bottom and a 3-wire electrical connector. That is your DPFE sensor (at least on the 3.0). To replace it, unplug it, pull the hoses from the pipes, transfer the hoses to your new sensor, slide the hoses and sensor onto the parallel tubes, and plug it in. Clear your code and you're done. Make sure you get a Motorcraft sensor. The aftermarket ones usually do not work. You can get them on Ebay cheaper than from the dealerThe Motorcraft DPFE sensor is 4U7Z-9J460-AA. This is an upgrade from the original sensor which was a bit smaller and had the stock number 2FIE-9J460-AB.
Is it ok to use 10W-40 oil in a 2000 Ford Ranger truck?
Yes it is fine to use 10W-40 oil
What is the oil pressure on 2001 Ford Ranger with 3.0 engine?
I'm not a mechanic / technician but I BELIEVE that is ( 40 to 60 PSI at 2,000 RPM ) for the oil pressure on a 3.0 liter V6 engine in a Ford Ranger
Oil pan gasket 2002 Ford Ranger replacement?
A replacement part for a 2002 Ford Ranger oil pan gasket will cost a price close to $40. The part can be purchased from a auto parts store.
What are the torque specs for the water pump on a 1999 ford ranger 3.0?
The 1999 Ford Ranger 3.0 liter water pump bolt torque specifications are 40 pounds. You do not want to torque the bolts to hard or they will break.
Where is the ignition module located on a 1994 ford ranger with a 40 liter?
its mounted under the hood on the driver side fender
Do all 1994 Ford Ranger 40 have an EGR Valve?
yes 2002 and later 30L are the only ones not equipped with an egr valve
Polaris Ranger speeds?
The polaris ranger speeds are, 500engine,40. 700engine,40-50. 800engine,55mph.
