0
Where is the ignition module located on a 1994 ford ranger with a 40 liter?
Wiki User
∙ 18y ago
its mounted under the hood on the driver side fender
Wiki User
∙ 18y ago
theodoes davis
Add your answer:
Earn +20 pts
Where is the ignition module located in a 1989 GMC 1500 Sierra 5.7L V8?
The ignition module on a 1989 5.7 liter is located in the distributor. Remove the cap, then the rotor, and you will be looking at the module. The module is held in place with two screws. Real simple. Good luck, David
Where is the ignition control module located on a 95 ford f150 4x4 supercab 5.8 liter?
On the distributor
Can you adjust ignition timing on a 98 Ford Ranger 3.0 liter?
Yes ANSWER No - a 1998 3.0 L Ford Ranger does not have a distributor which would allow you to adjust the ignition timing - it has a coil pack and the ignition timing is controlled by the PCM ( powertrain control module )
Where is the Ignition coil on a 1997 3.4 liter Pontiac transport located?
there are three coils located on top of the engine right at the fire wall, bolted to the ignition module
Where do you find the 4X4 module in a 2001 Ford Ranger 4.0 Liter V6?
I don't know if your Ranger is the same but on the 2001 Ford Explorer the 4X4 module is located behind the right front passenger kick panel
Where is the ignition control module on a 1984 Ford Escort 1.6 liter?
The ignition module is mounted to the side of the distributor. It a rectangular piece.
Where is the ignition control module on a 95 ranger stx 4.0 liter?
It's in front of the battery, inside of the radiator support, between the left headlight and radiator. The module is flat with the 12 pin connector facing upwards (towards the engine). Hope this helps.
Where is the ignition control module on a 1997 Sonata?
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
Ignition control module on a 92 ranger 2.3 liter located?
On my 92 2.3L it is located at the front of the intake housing on the drivers side black about 3 to 4 inches wide, 56 to 7 inches long(top to bottom) and maybe a half inch thick Be sure if replaceing to know which is the top side of the unit
Does 1990 Ford Ranger have a distributor?
The 1990 Ford Ranger 3.0 liter V6 engine has a distributor , the 2.3 liter - 4 cylinder and the 4.0 liter V6 have EDIS ( Electronic Distributorless Ignition System )
Were is the ckp and cmp located on a 1990 camaro with 3.1?
the 3.1 liter v6 uses the ignition module as the crankshaft sensor and there is no camshaft sensor because it is multi port injected
Where is the ignition module in a 1992 cutlass supreme 3.1 liter?
On the front of the engine under the two ignition coils, follow the plug wires and under the coils is the ignition module. Changed mine twice . Works better now.
