On my 92 2.3L it is located at the front of the intake housing on the drivers side black about 3 to 4 inches wide, 56 to 7 inches long(top to bottom) and maybe a half inch thick Be sure if replaceing to know which is the top side of the unit
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Yes ( according to motorcraft.com ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC
On the side of the intake manifold.
5.5mm bolts are the kind of bolts that hold the ignition control module in a 1987 Ranger 2.3L. However, 5.0mm bolts may also work.
It is secured with screws at the fenderwell.
In a 1997 Ford Ranger, the wiper control module is located behind the radio compartment. It sits on the left side of the compartment.
4.5 mm but has to be deepwell
The ignition module should be attached to the distributor with two small machine screws.
On the lh side mounted to radiator
Where is the key in the ignition warning chime module located on a 1990 Ford ThunderbirdRead more: Where_is_the_headlight_warning_chime_module_located_on_a_1990_Ford_Ranger_2.9
i replace the erg,tps,idle control module and ignition control module,and while driving past 30mph i loss power why