yes. Stupid
No, Qwest pipe and joints are OK with well water
If its producing water then its not a oil well there's water wells oil wells and gas wells Acidizing a well mostly after its been perforated will clean the perforations to allow a better flow of gas water or oil
Unless you mean the pipe that carries water to the surface, I can't imagine what you are referring to. .
If you are talking about a roof water drain pipe to sewer it is illegal. If you are talking about a sink drain pipe well that is where they all connect to so yea.
Well if you reduce the area of the pipe at the end, or anywhere else on the pipe for that matter, you are restricting the flow and it will be reduced. How much reduction depends partly on the water pressure available
Depends on local codes and the PH of the water
A well can be dug and the walls lined with stone or brick. A well can be drilled and a PVC pipe inserted with a smaller pipe inside to pump the water out. If there is no rock in the location, a pipe with an end on it can be driven directly into the ground. The end has a point on it and the sides have a fine screen covering it to keep dirt out of the water.
The salt water rate that is flowing from a well bore, that has 600psi and 22 choke, through a 2inch pipe at the surface will only have as much force behind it as the pipe can hold. This will depend on what the pipe is made of, and what weight it is capable of.
16 gallons
It either comes in a city 'water main' under the street, then into your home in a 1" pipe, or it comes from your well, into your home pressure tank.
An aquifer is a layer of water in the soil. A well is a hole drilled into that soil that will permit water to fill the lower levels of that hole. Water is then pumped from the well. A pump connected to a metal pipe is lowered to the bottom of the well. The pump is generally operated by a motor located at the surface. The pump forces water from the aquifer up the pipe and to the distribution point at the surface.
There are two types of jet pumps. Deep well jet and shallow well jet. The deep well has it's jet (ejector) in the well. The jets come in two different configurations. Two pipe and single pipe. The two pipe uses two pipes lowered into the well to the existing water level with the jet on the end. The single pipe jet is hung in the well with only one pipe. The jet has two leathers to seal it to the casing making the casing the second pipe. The shallow well jet pump has it's jet on or in the pump. These pumps can only lift water 25 feet. Once primed, the jet pump will force water down the pressure pipe into the jet, where it will be sent through a nozzle (of differing sizes depending on pump and water level) and into a Venturi tube (also differing in sizes) which creates a vacuum that will send more water up to be captured in the storage tank.