Depends on local codes and the PH of the water
Yes.
No, Qwest pipe and joints are OK with well water
It is a metal pipe that was used before PVC and cpvc. I hate it, it know from closing shut whicjlh in turn well cause little to no water pressure. If ya go it, get it replaced. If you don't you'll be taking drip drop showers. <><><> Steel pipe coated with zinc metal (that is the galvinized part) which delays rusting.
Unless you mean the pipe that carries water to the surface, I can't imagine what you are referring to. .
It is a metal pipe that was used before PVC and cpvc. I hate it, it know from closing shut whicjlh in turn well cause little to no water pressure. If ya go it, get it replaced. If you don't you'll be taking drip drop showers. <><><> Steel pipe coated with zinc metal (that is the galvinized part) which delays rusting.
Yes. Use a threaded fitting, male or female as needed on the copper and screw the galvanized into it.You must use a dielectric fitting to connect copper to galvanized pipe. If you don't, a galvanic reaction will occur and the piping will corrode and leak. You can use a Dielectric Union or a Threaded Brass fitting to join the two types of piping together.UNIONS can leak the best answer would have been a dielectric nipple
NO..copper,black iron, galvanized for gas pipe.never use plasticp solvents or glue.gas does not react well with other chemicals.
If you are talking about a roof water drain pipe to sewer it is illegal. If you are talking about a sink drain pipe well that is where they all connect to so yea.
yes. Stupid
You first must know if you have a Pitless Adaptor or just a Well Seal. You will need a couple of pipe wrenches and some way of holding the pipe while you take apart each joint. The joints unless you have Poly Pipe should be 21' lengths for galvanized pipe or 20 foot for PVC pipe. If you do have Poly Pipe, it will be all one piece with joints at either end only. Be extremely careful not to drop it. If you drop it, you may never see it again.
Well if you reduce the area of the pipe at the end, or anywhere else on the pipe for that matter, you are restricting the flow and it will be reduced. How much reduction depends partly on the water pressure available
A well can be dug and the walls lined with stone or brick. A well can be drilled and a PVC pipe inserted with a smaller pipe inside to pump the water out. If there is no rock in the location, a pipe with an end on it can be driven directly into the ground. The end has a point on it and the sides have a fine screen covering it to keep dirt out of the water.