Should be individually vented
Yes as long as the drain has a trap and is vented
It's not the toilet, there's a blockage in the pipes some where after the drain pipe from the toilet joins up with the drain pipe from the tub.You're going to need to have the pipe snaked.
You need a basement toilet system. There are 2 basic types, one has a small pump that pumps each flush or use of a faucet to level immediately. The better system has a 40 gallon bin fitted in the basement floor with a septic pump in it. This operates on a float switch and pumps about 25-30 gallons of liquid when the switch is triggered.
The main drain is plugged. You may need to remove the toilet and snake directly down the drain.
This could be an indication of a blockage or you may need to install more venting lines.
Probably not. There is no vent for that drain, it did not need one for a floor drain. A toilet is trying to push against the air pressure in the drain.Normally a decent plumber will install a floor drain with in 15 feet of a vented line or will vent the FD in case irt exceeds the 15 ft ruleA Floor drain can be as small as 2" diameter and thus it is undersized for a toilet and a floor drain alread has a trap and a toilet would thus be drouble trapped
form_title=Basement Drain Repair form_header=6903 How would you describe the interior channels you need to have repaired?*= () Plastic channels behind baseboard () Channels dug into concrete slab () Covered channels buried in slab () Don't Know How would you best describe the problem?*= () Channels can't handle water volume () Channels not sloped properly to drain () Channels drain to faulty sump pump () Channels are clogged () Bad odors () Requires cleaning/maintenance
That would be your flush valve in the tank
Most Toilets in basements are generally already to go ,they are hook in to the main 3" line anyway which goes directly to the roof for ventilation .the toliet in the basement is the last fixture before going to the subdivision in sewer line.this is how it is in Atlanta Ga...I am a builder here and i do many basement rooms..The trick is venting out the fart fan ,but there is a cure for that to
Depends upon the plumbing code in your area.... A traditional ion-exchange water softener does need a "drain line". Typically 10-50 gallons of water are sent to the drain during each regeneration . Depending upon the local plumbing codes this drain could be: - a floor drain - a deep-sink drain (wash basin) - plumed directly into the household sewer drain (typically this installation uses a device called an air-gap)
the sink drain is prob.in the wall.you would have to get a wall mount commode,or install drain in floor and plug drain in wallAnswerYou also need a 3 or 4 inch drainpipe.Ans 3 - You can do this if you fit a new 3" drain to the main pipe and run it to a toilet flange where the sink is.
You need at least a 3 in. pipe -- shower is 2 in. pipe