0
Does a troy-built 21 inch cutting blade 190cc 6.75 need an oil and gas mix?
Wiki User
∙ 10y ago
A Troy-Bilt 21 inch cutting blade 190cc 6.7 HP engine does not need an oil and gas mix. It is a 4 cycle engine which keeps the oil and gas separate for maximum efficiency.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What type of metal would need a hacksaw blade which uses 32 teeth per inch. (t.p.i.?
A blade with those teeth is for cutting very hard metals.A blade with those teeth is for cutting very hard metal
How many inches should you keep your fingers away from the cutting blade when the saw is on?
about an inch
What type of metal would need a hacksaw blade which uses 32 teeth per inch?
A blade with those teeth is for cutting very hard metals.A blade with those teeth is for cutting very hard metal
What type of saw blade would you use in a circular saw for cutting a quarter inch backer board?
a concrete or masonry blade
What size cutting blade does a Trim-Rite model tr553b gas edger use?
9 Inch
What wood are jigsaws made from?
A good quality jigsaw will cut almost any material with the correct blade. Although I have 3 jigsaws my favourite is the Bosch1578AVS that I've had over 30 years. I still use it 3-4 times a week to cut wood of different kinds, plexiglass and steel. The steel cutting blade is like a very fine hacksaw blade with 24 teeth per inch. An average wood cutting blade will have about 8 teeth per inch.
How do you find the right blade for your jigsaw?
You have to look carefully on the blade package, where it says how many teeth per inch, hardness of steel and what the blade is most suited for. Generally speaking, wood blades have bigger and fewer teeth, whereas metal cutting blades have lots of very small teeth.
What does a hacksaw cut?
A hack saw is for cutting metals. It has a disposable blade and you can choose from many tooth sizes and teeth per inch, this allows cutting of a wide range of metals, soft to very hard.
What blade to saw particle board?
A carbide blade with large teeth about 3 per inch.
How many teeth does a table saw ripping blade have?
At least 40 teeth on a 71/4 in circular saw blade
Is the bolt that fastens the cutting blade on a Craftsman forty two inch lawn tractor a standard thread or a reverse thread?
I've had 4 Craftsman mowers. All have been right hand (standard) thread.
What are the differences between rip saw and tenon saw?
A tenon saw has a rigid, solid rectangular blade about 12inches long and 3-4 inches wide, and around a 1/32 inch thick and has a reinforcing strip of metal along the top edge of the blade to keep it straight and rigid. It is used for cutting wood joints accurately, and can only cut in straight lines. A copingsaw, however has a much thinner narrow blade stretched in a frame shaped like a 'D' with the upright of the 'D' being the blade. The handle is in line with the blade. Coping saws are used for cutting round and complicated shapes out of wood (or, with a suitable blade, metal). The thin blade means that the saw is able to cut out complex shapes accurately as the saw blade can reach small corners and follow quite complex shapes. A fret saw is very similar to a coping saw except that the 'D' shaped frame is very elongated and the blade very fine and thin. This saw is used for cutting intricate decorative shapes out of thin wood. A scroll saw is a motorised fret or coping saw where the blade moves up and down through a metal table. Instead of moving the blade through the wood or metal, the wood or metal is moved round the moving blade, producing the intricate cut.
