If you had a really bad slipping serpetine belt and get a new belt you would feel a difference as the old one would affect the spark in spark plugs, but a new belt would also cause more friction because its more rubber thus reducing power output by a little bit.
The serpentine belt tensioner is held in place by one bolt. The retaining bolt goes through the middle of the serpentine belt tensioner pulley.
Put the serpentine belt on to the pulleys of your 1994 Chevy engine. Tighten a serpentine belt with the tensioner pulley.
Loosen the tensioner pulley on your Monte Carlo 3.1 liter engine. Slide the tensioner pulley to the right. The serpentine belt can be removed. Put the new serpentine belt on and slide the tensioner pulley to the left.
on the front of the engine on the serpentine belt, it's bolted directly to the engine.
To get the serpentine belt off an engine fan, loosen the tensioner pulley. This pulley is the one with a bolt in a slot that can be adjusted. Then remove the belt.
The zd30 has a hydraulic tensioner using an idler pulley to automatically tension the serpentine belt.
you have to remove the belt tensioner to remove the belt off of the engine.
The tensioner is the arm on the passenger side of the engine near the front that has a pulley on the end and controls the tension of the serpentine belt. www.trailvoy.com
The serpentine belt you can look at the diagram in your engine compartment for actual routing. The tensioner mounts to the left side of the engine. You need to unbolt the whole assembly. Actually, the belt can be loosened by tightening the bolt of the tensioner pulley. When fully tightened, the pulley will act as a swivel.
remove the belt. then in center of the tensioner is a bolt that goes into engine. remove this bolt. then tensioner should come off.
This is a serpentine belt that runs all of the pulleys on the front of the engine. There is a separate tensioner pulley and not one for the water pump alone. A bad tensioner will allow the serpentine belt too much slack which will allow the belt to slip and yes, the engine can overheat as a result.
Worn serpentine belt and/or belt tensioner.