Check the wire which supplies energy for tail lights (the junction between the trunk and the car body). If it's broken it will cause the check engine come on.
Change engine oil, or check oil indicator?
Mine did the same thing and shortly after my alternator had gone.
A watt engine indicator is used to perform a measurement of the amount of steam pressure in a cylinder. This process is completed with the assistance of a manometer.
A malfunction indicator light is also known as a check engine light. It is a light on the dashboard of a car that goes on when there is a problem with the car's engine.
What indicator are you referring to? Are you referring to the Check Engine light? If so, it is on because the ECU has detected a problem with the emissions system.
Simply turn on your engine, then momentarily press select button display followed by holding down the set button
Turn key to on position with out starting. Press the select/reset knob until the "engine oil life indicator" is displayed. Hold down the knob for at least 10 seconds. The "engine oil life indicator" will blink. Hold down the select/reset knob for at least 5 seconds. The "engine oil life indicator" will be reset to 100%.
To reset the service indicator on a Mercedes R129, turn the ignition key to position "2" without starting the engine. Press the gas pedal three times within 10 seconds, then turn the ignition off. When you turn the ignition back on, the service indicator should be reset. If it doesn't reset, repeat the process to ensure all steps were followed correctly.
The check engine light on the Honda Pilot is an indicator that there may be a problem with the engine. This could be minor such as air or water in the gas tank or could be an indicator of something more serious.
Yes.Of couse it does.
The Service Vehicle Soon indicator is usually a light bulb, headlight, or something to do with the vehicle. The Service Engine Soon indicator is anything that could be wrong with the Engine. Some computers can read codes for either, but some computers can only read codes for the Service Engine indicator.
the first engine was 10 cc but shortly after that they built a 25cc engine