You can use a C-clamp to compress the caliper on just about any vehicle. You might want to place some rags near the Brake Master cylinder because brake fluid will travel back into it from what is left over in the brake lines. If you don't, you will spill brake fluid onto the floor.
Air will compress under pressure, hydraulic brake fluid doesn't. Air in the system will give you a spongy peddle because of that.
No.
They compress the brake fluid and push the brake shoes out against the brake drum stopping the vehicle.
Well it kind of depends on what the piston looks like. Does it have two holes on the head of the piston? If so, you will either need the special tool to compress it or you can try to use a set of needle nose pliers to push and turn it at the same time. If it doesn't have the two holes then all you should have to do is take the old brake pad and put on the piston (shim side to piston) get a C clamp and compress it (the brake pad will help protect the piston as well as help to provide even pressure across the piston as you compress). It may take some pressure but eventually you should see it start to compress. I have done several brake jobs myself and this way works the best. Hope this helps and goodluck. note* - I have read that when compressing the piston you should have the bleeder screw open to allow some of the fluid to escape as you compress the piston. Also you could have the brake fluid reservoir cover open to allow for the fluid to escape that way. I have done both and they have worked fine for me.
It uses brake fluid in the brake fluid reservoir. The clutch fluid (brake fluid) is fed by the brake fluid reservoir. The clutch fluid reservoir is just beneath the brake fluid reservoir. So, add fluid to the brake fluid reservoir to fill the clutch fluid, also.
You can purchase a disc brake tool for compressing the calipers at any auto parts dealer for about $8.00. You will also need to have the brake fluid filler cap off. You can purchase a disc brake tool for compressing the calipers at any auto parts dealer for about $8.00. You will also need to have the brake fluid filler cap off.
Luid You can open the cap on the fluid container when you compress the calipers back it will force the fluid back and then you bleed them to remove any air in the lines.
Yes. Normal brake fluid is actually synthetic
It is important to maintain the brake fluid levels in a car. The brake fluid type for a 2002 Grand AM is DOT 3 brake fluid.
NO! Brake Calipers are what compress your Brake Pads on to the rotor which turn simeultaniously with your wheels.
Only brake fluid can be used for brake fluid. Brake fluid is a glycol-based liquid - it's closer to antifreeze than to oil, but don't use antifreeze in it either. Only brake fluid.