Want this question answered?
All amplifier typically exhibit a band-pass frequency response. The cut off frequency in the low end is usually determined by the coupling band bypass capacitor .and the high frequency limit is typically determined by internal capacitances in the transistor itself.
Cut off frequency is that frequency at which the power output of the circuit reduces to half of its power in pass band. Power (P)= Current2 X Resistance. so to reduce the power by half we need to reduce the current by 1/sqrt{2} = 0.707 = 3 db. So it's also called half power frequency. http://enter4joy.com
The cut-off point is the exact point where the load line crosses with the vector axis. The saturation point is the point where the load line intersects with the collector current axis.
water can cut through glass but only when at a very high speed and a thin stream
Different methods for different circuits. In a simple RC filter with a series R and shunt C, the time-constant T is equal to RC. The cutoff frequency is given by 1/(2.pi.T). So with 1 k-ohm and 0.1 uF the time-constant is 1000 x 1E-7 or 100 microseconds, so the cutoff frequency is 10,000/2pi which is 1592 Hz.
they are used in industries so to able you to work on particular frequency and cut the other for e.g if you are working for high frequency then low frequency will be cut and vise versa
A High Pass Filter is an Electronic Filter that passes high frequency signals but Attenuates (reduces the Amplitude ) of Signals with frequencies lower than the cut-off Frequency
Collector-to-Emitter resistance is high when the transistor is biased off.
Yes, they are both filters. But their frequency characteristics are different. This is the main reason why they are given different names. A high-pass filter passes frequencies higher than its cut-off frequency, and stops those that are lower. A low-pass filter passes frequencies lower than its cut-off frequency, and stops those that are higher.
All amplifier typically exhibit a band-pass frequency response. The cut off frequency in the low end is usually determined by the coupling band bypass capacitor .and the high frequency limit is typically determined by internal capacitances in the transistor itself.
it is the frequency at which the current amplification drops 3dB below its low frequency value.
The relation between cut off frequency (fc) and band width is as follows: fc=Q*B.W where Q=(fL*fH)^1/2/(fH-fL) Q is quality factor. fL is low frequency. fH is high frequency.
Death Collector - 1988 is rated/received certificates of: UK:15 (cut)
Final Cut Death on the Silver Screen Collector's Edition - 2012 VG was released on: USA: 5 May 2012
Munifent
The wavelength of a wave would double if the frequency was cut in half. Wavelength=c/frequency where c equals the speed of light.
Cut off frequency is that frequency at which the power output of the circuit reduces to half of its power in pass band. Power (P)= Current2 X Resistance. so to reduce the power by half we need to reduce the current by 1/sqrt{2} = 0.707 = 3 db. So it's also called half power frequency. http://enter4joy.com