It is a conductor & common in wiring.
Electron current in a copper wire is normally composed of electrons.
Copper, the usual use for wire, is a great substitute for gold. Figuring it is much cheaper as well as easier to work with. Copper wires should be covered with rubber or plastic coverings. Copper is a conductor, like gold, in other words, it can carry an electric current. Good Luck!
this is because copper wire offers no resistance and thus electric current passes through them without producing heat energy whereas in nichrome offers a large resistance and thus the mechanical energy of the drifting electrons changes to heat energy rapidly .
yes Polyvinyl Chloride (PVC), and rubber are both good insulator's
because electricity is not wasted
Electron current in a copper wire is normally composed of electrons.
The copper wire carries an electric current.
In the electrical trade aluminum wire is equivalent to copper wire as it is also used to carry current. To carry the same current as copper wire aluminum wire is up sized to meet the same ampacity.
Because the metal Copper is a very good conductor - of both electricity and heat - copper wire can be used to carry an electric current in an electric circuit. The electric current consists of a flow of electrons.
Electric current in a metal conductor is carried by a wire. This wire has been specifically adapted to carry this current.
30amps
Copper wire has apparently lower resistance than the reed switch. The lower electric resistance, the higher electric current.
A wire has to be made of a conducting metal such as copper or aluminium, and it has to be thick enough to carry the required amount of electric current. Wire is often given an enamel coating to insulate it Wires are often stranded which gives flexibility.
Wire is the transition material used to carry the electric current; the switch is the controller of that current.
A thicker wire will transmit more current
#8 RW 90 degree wire
No, copper wire cannot be used to make the filament of an electric bulb as copper wire has very low resistance. Therefore, the bulb will not glow if current is passed. It would also melt - the filament has to be white-hot to be any use!