There are diode tubes that can make noise, but they have not been popular for a number of decades.
The solid-state diodes that you find on printed-circuit boards have no moving parts, so are silent, unless they have been damaged in some way.
The built is voltage would be lower than silicon diode,more leakage or reverse saturation current,poor thermal stability,high noise and greater conduction in comparison to silicon diodes.
Bad bearings in an alternator would make a grinding or roaring sound. If a Diode Plate is failing you might hear a buzzing sound in the radio that changes pitch with the speed of the engine.
the diode is forward bias ANSWER: A bypass diode is used to bypass circuitry as soon as the diode is forward bias by 0.6 volts The use it to bypass to prevent damage to the circuitry
a diode can be make using p-n junction....form a p junction n form a n junction...and after joining them u cn make a p-n junction diode....for making a diode u ll ve to face doping problems
yes
They make noise by making it.
The output current of a PIN diode is proportional to the light incident . Whereas in APD due to internal multiplication (Avalanche multiplication) of primary photocurrent, higher gains are possible. A small signal current output from the pin diode are to be amplified before applying to next associated receiver circuit. This includes thermal noise in the main signal, giving lower, receiver sensitivity. In case of APD, photocurrent is multiplied before encountering the thermal noise amplifier, giving increased receiver sensitivity.
Hole-Accumulation Diode. It allows more light to pass to each pixel, increase sensitivity, and reduce noise.
you are forbidden to make a noise
The Noise We Make was created in 2001.
Beetles make a clicking noise!! (: (: (: (:
They dont make noise only interference