answersLogoWhite

0


Best Answer

No, the plugs can be accessed from underneath or by removing the upper intake.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does hood have to be removed to change spark plugs chry T and C 3.8 van?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is there a access hoe for the fuel pump on a 2000 chry concord?

No there is not. The tank must be removed the replace the fuel pump.


When was CHRY-FM created?

CHRY-FM was created on 1986-06-01.


What are the legendaries in Pokemon chry stal?

sucine, entei, and raikou


How many syllables are in the word chrysalisis?

Three. (Chry-sal-is) You spelled it wrong.


What is the blinking light on top of dash when you shut off car of a 1999 chry. 300m?

The alarm


How many syllables are in chrysalis?

The word chrysalis has three syllables. The syllables in the word are chry-sa-lis.


Dodge Dakota are they junk?

I have a 97 4x4. Have had very few repairs done.But with all Plymouth/Chry/Dodge the parts cost more then Ford & GM. because Chry has it set up where you have to get the parts at a dealer. If you go to a junk yard you don' find to many Dakotas or rams in there.


What does the code 9ascap mean on a 2006 chry town and country?

The message is "gascap". Check to see if the gas cap is not tightened properly.


2004 chry 300 have a safety switch if you loose oil pressure to shut engine off before engine is damaged?

No, it doesn't have such a switch.


Where is the Museum Store Association Inc in Denver Colorado located?

The address of the Museum Store Association Inc is: 3773 Chry Crk North Dr Ste 755, Denver, CO 80209-3804


What is a 2007 CHRY TOWN EGR position sensor?

An EGR (Exhaust Gas Re-circulation) valve position sensor sends a signal to the ECM (Engine Control Module) what the EGR valve position is. This is to confirm that the EGR has responded to a command sent from the ECM.


94 Chry. TC instrument cluster-I replaced it like IronMike told me There must be a fuse somewhere because the only gauges that still work intermittently are rpmbatt.speed. No fueloiltemp. gauges?

when you had that problem did the van start? we have the same stuff going on but ours wont start