Yes.
I believe it is mounted on the firewall , just to the right of center
The horsepower on the 1988 Mustang was # 90 horsepower 2.3 liter engine # 225 horsepower 5.0 liter engine
The oxygen sensor on the 1988 ford 2.9 liter engine is located on the exhaust pipe just behind the right exhaust manifold. It screws into the exhaust pipe and has a small wire running to the tip of it. Just unplug the wire and turn out the sensor with a wrench.
The 1988 Toyota oxygen sensor is located on the air cleaner housing. You will find the sensor, on the back side of the housing.
Rear of engine follow exhaust manifold at rear of motor(closest to firewall) you will see oxygen sensor there.Simple to remove(1 only on this motor)
I think you mean CAMSHAFT position sensor.
From the factory ( 220 horsepower ) for the High Output 5.0 liter / 302 cubic inch V8 in a 1988 Ford Mustang GT
The oxygen sensor in a 1988 Cadillac Deville is located in the exhaust manifold. It constantly monitors oxygen levels in the exhaust to allow the engine to operate and peek efficiency.
If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.
BCI group size ( 58 ) 540 CCA
I'm not a mechanic / technician but on a 1988 Ford Ranger there might be ( 1 ) oxygen sensor ( upstream sensor )
The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.