0
The oxygen sensor on the 1988 Ford 2.9 liter engine is located on the exhaust pipe just behind the right exhaust manifold. It screws into the exhaust pipe and has a small wire running to the tip of it. Just unplug the wire and turn out the sensor with a wrench.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Does the 1988 ford mustang 2.3 liter have just 1 oxygen sensor?
Yes.
Where is location of oxygen sensor on 1988 Pontiac Bonneville 3800 liter motor?
Rear of engine follow exhaust manifold at rear of motor(closest to firewall) you will see oxygen sensor there.Simple to remove(1 only on this motor)
Where is the oxygen sensor on a 1988 Chevrolet celebrity?
If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.
Where is the oxygen sensor on a 1988 cadillac deville?
The oxygen sensor in a 1988 Cadillac Deville is located in the exhaust manifold. It constantly monitors oxygen levels in the exhaust to allow the engine to operate and peek efficiency.
Where is the knock sensor a 1988 2.8 liter?
It should be on the side of the engine block over by the starter.
Where is the oxygen sensor located on a 1988 Honda prelude fuel injected?
The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
Where is the oxygen sensor 1988 regal?
oxygen sensors are on the exhaust pipe close to the engine. Some are on the exhaust manifold. some may have an upstream and a down stream sensor.
Where is the oxygen sensor on a 1988 Toyota?
The 1988 Toyota oxygen sensor is located on the air cleaner housing. You will find the sensor, on the back side of the housing.
What is the real horsepower of a 1988 mustang?
The horsepower on the 1988 Mustang was # 90 horsepower 2.3 liter engine # 225 horsepower 5.0 liter engine
Where do you find map sensor on Chevy 1988 5.7 liter?
The MAP sensor is located on the passenger side of the engine. It has a 6 inch bracket that it is mounted on that is on the intake manifold. It should have a vaccuum line and a plug in it.
Where is the hall effect sensor located on a 1988 Chevy S-10 pick up with a 2.5 liter engine?
it's located on the top underneath the rotor of the distributor
What is the towing capacity of a 1988 4.2 liter Jeep Wrangler?
You should not tow more than 2,000 pounds in a 1988 Jeep Wrangler. This is considering the engine is a 4.2 liter engine.
