answersLogoWhite

0


Best Answer

With most heaters in vehicles the blend door mixes hot and cold air together to give you the temperature you want. Thus the name blend door

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does the blend door actuator direct where you want the heat to go?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Could it be the blend door actuator that is not allowing your heater to go off?

Yes, it is possible the blend door is broken in the heat position.


Where is the location of the blend door actuator on a 2002 gmc Yukon Denali?

need to know were the blend door actuator is for a 2002 gmc yukon on the drivers side , dual climate controls, rear air and heat


Why is the heat always going out on your Chevy Blazer?

The temp blend door actuator is probably at fault.


Where is the blender door on a 1995 Chevrolet K1500?

There is actually 3 blend doors on the plenum. The blend door actuator is on the top of the case. It controls heat and cold air.


Is there a switch that controls the heat on a 2001 s10?

There is a temp blend door controlled by the temp control switch. The temp blend door is run by an actuator. If this actuator needs replacement it requires removal of the dash assembly (big job).


Why Does your 1991 Chevy S-10 Blow Heat All the Time?

The temp blend door actuator is broken.


2000 dodge ram what is the little motor or gearbox that moves the damper for heat or cool called?

Blend door actuator.


Driver sideon dual control wont heat on impala?

Driver side temp blend door actuator has failed.


Where is the temperature blend motor actuator on a 2001 ford windstar?

The blend door actuator is located behind the glove box, and a sign of failure is an audible "clicking" sound when you adjust your climate controls. The most common issue with heat or A/C in the late model Ford windstar is a broken blend door. A broken blend door actuator is almost as common as a broken blend door itself. Typically, the fix requires disassembling the entire dash and replacing the whole plenum box, which can be a costly repair.This details the best DIY option on how to replace a broken blend door or actuator, accessing the plenum box by removing the glove box rather than the entire dash.


Why is the Heater stuck on high temp on a 2001 mercury sable?

This sounds like a temperature blend door problem - with the door stuck in the heat position. See "Related Questions" below for information on Taurus/Sable blend door actuator motors and blend doors


Weak heat ford?

Could be, low on coolant, bad thermostat, plugged heater core, faulty temp blend door actuator,


What causes high heat in the left side of a 1998 olds bravada center console?

Probably a faulty temp blend door actuator.