NO nothing hooks to it.
where is the oil pressure switch on a 1999 chevy surburban
It is most likely on the fuel pump
fuel pressure regulator 99 suburbanI have a 99 suburban 2500 with a 7.4 motor. In it the fuel pressure regulator is just below the distributor to the right. I had to remove the upper manifold and pull the distrbutor to change it. Wasn't as tough a job as it sounds, just took a while. Hope this helps. On a 99 Chevy suburban k1500 5.7L, the regulator is directly under the intake manifold. It is connected to the passenger end of the SCPI fuel injector assembly. You can't see it until you remove the manifold. It is held on by a clip that can easily be removed with a flat-head screwdriver. If you remove the regulator, take note of which direction the clip is facing because it will only go back on one way.
How do you replace a starter in a 1999 suburban
Then you have a BAD fuel pump. Replace the pump and filter. If it is higher then 63 LBS. then the fuel pressure regulator is bad.
The fuel pressure regulator is located under the upper intake manifold. It is attached to the bank of injector poppets (aka, the spider).
I have the check engine light on and the code is for map sensor on my 1999 1500 Chevy suburban
where is the fuel pressure regulator on a 1999 GMC SAFARI? thank you
I have a 1999 Suburban-JB6 brakes. The drum size is 11"
How to remove the window motor from the regulator
Yes.
I have a 1999 Chevy Suburban LT and if I stay at the recommended hwy speed I easily get 19mpg