The resistance of the coil does not remain the same throughout the experiment because the voltage across and the current is varied.
Typically resistance rises with temperature.
Typically resistance rises with temperature.
If dc current is passed through a single coil, it is going to remain constant.
The formula you are looking for is R = E/I. Resistance = Volts/Amps.
The energy transfers in the electric coil of a baseboard heater involve electrical energy being converted to thermal energy through the resistance of the coil. When current flows through the coil, the resistance generates heat, which warms the surrounding air in the room.
The current flowing through the heating coil will depend on the resistance of the coil and the voltage of the power source. Using Ohm's Law (I = V/R), where I is the current, V is the voltage, and R is the resistance, you can calculate the current. The higher the voltage or lower the resistance, the higher the current.
An ammeter consists of a coil with very low resistance. when electric current flows through the coil, the coil induces a magnetic field which turns the needle.
The strength of an electromagnetic is determined completely by the current through its coil, and doesn't depend on the voltage across the coil. The voltage will be (current) x (resistance of the coil).
The coil offers some amount of Resistance to the flow of Electric current through the coil. The Resistance of the coil depends on the material used to make the coil and the thickness of the coil wire ( its gauge ) When a current flows through the coil, the voltage drop across the coil and the Power dissipated in the coil both are proportional to the magnitude of current and the coil resistance. Normally the coil is rated to carry certain current and dissipate certain amount of power without causing any damage. If a large magnitude of current flows through the coil beyond its rating , the voltage drop across the coil and the power dissipation in the coil both increase substantially causing over heating of the coil. This can damage the coil and may result in burning of the coil
The resistance to the electric flow through the wire coil causes heat
The voltage (or 'potential') coil has the higher resistance, because it is connected in parallel with the load.
A copper coil heats water when electricity passes through it, generating heat in the coil due to its electrical resistance. This heat is transferred to the surrounding water, raising its temperature.