No just make sure the holes are close and its not a cheep one
The valve is not be diverting all the water. This valve may need to be replaced.
A trim kit is just the outside parts that you see. This will make you faucet look better, but it wont affect the function of your old valve. If your shower valve doesn't work right, replace it.
The best way to make a mixer design is to review past designs of standing and hand-held mixers. You need to consider size and shape when you start to design a mixer.
You do not need a high shear mixer to make your own laundry detergent at all! A home mixer will do the job just fine and you won't have to worry about the expensive cost of a high shear mixer!
i would advise that you get some Teflon tape at the hardware store this will help seal the screws so water doesn't leak out when you turn it on. 1. first you need to unscrew the shower head off.2. then wrap the screw threads in the Teflon tape(this part can be a little tricky and if you know anything about telfon you can quess why).3. then just srcew they new shower head on but make sure you do it nice and tight. that's for your standard shower head but if you have one of those hose shower heads there some extra steps and a lot more teflon. 1. do steps 1-2.2. then but on the base that holds the shower head. 3. then wrap teflon on the part of the hose that goes in the base.4. put hose in base.5. attach hose to head then put head in base holder. That how you but on a new shower head.
Need to know the voltage of the mixer.
For Moen, there is a part called a "posi temp" and this can be replaced to manage the hot water. You may need a specialized tool called a puller. There is an amusing You Tube with Steven Lavmoniere that shows the process to do this.Maybe. If it is a Moen or other type of single handle shower valve, try changing the cartridge first. If this doesn't work, you need a new shower valve.ANS2 - Shower valves of all types will clog up with any bits of sediment or rust in the system. This is very common. Take the valve apart and check carefully inside.
First decide if you want to take a shower valve repair yourself, or contact a plumber. If you decide to repair the shower valve yourself, first you will need to shut off all water to the shower and tub.Next, turn the valves to the on position to relieve any pressure, and remove the set screws. Next, remove the trim ring and save all of the gaskets. Take all of the valve parts to a home improvement store where they will assist in finding you all the replacement parts. Lastly, you'll need to put everything back together in reverse order.
You need to buy the extractor tool from Home Depot.
When delta made a shower valve with the 3 silver soldered soft copper extensions on the valve they didn't know what kind of disaster they created. When you try to change the rubber rings and springs in the valve, it can be impossible to take the main nut off with out tweaking the valve because the chrome escutcheon that doesn't come off unless the main nut is off just spins freely when you need to hold the valve while you try to unscrew the main nut. What I found out to be the easiest way is to cut the chrome escutcheon completely off and then you can grab the valve with pliers and not twist the valve body, of course you will need a new escutcheon when your done replacing the parts of the valve so the next plumber or homeowner can do the same thing later on. I can only imagine the billions of escutcheons they need to make for that very poorly designed valve.
All you should need is a mixer and some milk.
Probably not, if the cupboard has doors that close completely. This will prevent dust from getting to the mixer. A mixer cover is a necessity only if the mixer spends most of its time on the countertop.