Want this question answered?
No, insurance is your responsibility.
the wirehas been eaten by rates of mouse
Yes - whether it was pre-installed on your computer, or you purchased a legal copy from a computer shop - it includes a permanent license.
California license plates come in a few different styles. The most popular plate is white with the word California in red cursive lettering.
The Honda Pilot does not come with pre-drilled holes for a front license plate bracket so first you have to drill the holes. Once the holes are drilled then you can use the screws that came with the bracket to secure it into place.
my name is Jesse fondotsto replace a license plate light you first have to open the trunk of the car take out the carpet on the top of the trunk after that you will see two little black screws you take them out after you do that the silver peice will come off but before you can replace it you must take the two little screws out that are located right above the license plate. your welcome!
The state slogan is: New Jersey, Come See for Yourself. The state license plate says: The Garden State
Not all vehicles come from the factory withe the front plate bracket installed. If you don't easily see it, then you will have to buy one from the dealer.
The license plate light on a Lexus may turn on and off if there is a loose wire. Try wiggling the wires around and see if the light goes on and off. If it's not a loose wire then the light bulb may have come loose and needs to be tightened.
you can see the plugs on the back of the light. lift the trunk and look past the license plate . the twist out . righty tighty lefty lousy . pull them out. its tight but they come out. use needle nose pliars, but be gentle.
License plate like bulb, on a Citrogen Picasso, can be changed by pushing the bulb in and turning at the same time. The bulb will come out. Insert the new bulb.
Open the trunk and look for the wires that connect to the license plate lights. You should see a plastic piece that hooks into a socket. Simply grab the plastic piece and turn and the lights should come right out. The lights may be behind a paneling.