answersLogoWhite

0


Best Answer

4 + 4 wired in paralell + to + and - to - will give you 2 ohms.

do this on both subs and then wire them together + to + and - to - and that will give you 1 ohm. so now get an amp that is 1 ohm stable 95% of mono block amps are. add your subs rms wattages together not peak let say your subs are 1200 peak and 600 rms then 600 + 600 equals 1200 watts rms is what you need.

so for this instance i would need a 1200 - 1500 watt rms mono block 1 ohm stable amplifier. I like more power just in case after the subs get broke in they want more power.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Dual 4 ohm subwoofer what kind of amp should you use?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What kind of amp should you hook up one lightning audio subwoofer 300 watts to?

Buy a cheap Jensen amp the 250watt 1.


What size of an amp should you get for a subwoofer in your 03 Jeep Liberty?

It depends on the power rating of the subwoofer.


What is a passive subwoofer?

A passive subwoofer doesn't have a built-in amp and will require the use of an amp.


Does subwoofer have fuse?

No the subwoofer itself does not contain a fuse. The Amplifier Connected to the sub should consist of a fuse or the power wire leading to the amp should contain one.


Why does your car stall after installing a subwoofer?

your car should not stall after installing a subwoofer. your problem might be the fact that your amp and your subwoofer(s) could be using too much of your cars electricity.


What should the low pass filter be set to?

If it is a subwoofer amp then set it at about 80 hz.


What amplifier power will I need to power dual 12" Rockford Fosgate subwoofers?

A Rockford 250 watt amp would compliment a 12" Subwoofer very nicely.


Is there an amp for the subwoofer in a 2001 Lincoln Navigator?

The amp is right next to the subwoofer. They are both located behind the rear driver side panel.


What is the largest pyle subwoofer?

You can get an 18" Pyle subwoofer but you will also need a large amp for it.


What amp do you use for a car subwoofer?

You must first check with the guide to your subwoofer. Either you can probably find it online , but you need to know the RMS wattage for the subwoofer. Than buy an amp that can put out the same number of watts and the RMS is for the subwoofer.


What type of Amp do I need to run the Kicker 08DS12L72 Dual 12 in. 1500 Watts Enclosed Car Audio Subwoofer?

Any amp capable of pushing up to 1500 Watts will do the trick, and shouldn't be too expensive to come across.


Can a subwoofer work without an amplifiers?

Yes a subwoofer can be plugged into a stereo without an amp but it wont sound good and wont hit anywhere near as hard as if you had it runnin through an amp... get an amp