It's located on the center radiator support at the very front of the vehicle. It lives towards the radiator, on the center support, towards the bottom.
its close to your bung hole
the sensor is in the front timing cover of the engine on pass.side above the crank pulley,10mm wrench will remove
location of camshaft sensor is on the front of the block above the bottom pulley wheel. this is easiest accessed from underneath the vehicle
behind the powersteering pump on the driver side it is hard to see
Next to the lower radiator hose where it connects to the water pump. You need to get under the vehicle to see it
On a Ford F-250 : Bank 1 is the passenger side of the engine Sensor 2 would be in the exhaust after the exhaust exits the catalytic converter ( downstream sensor )
On a 6.0 diesel
The air intake sensor on a 1991 Ford F-250 is located on the top of the engine. It is mounted just behind the distributor.
To install a cylinder head temperature sensor on a F-250, you disconnect the cylinder head sensor from the electrical connector at the rear of the cylinder head. When installing the new one, you reverse the process of removal. The cylinder head temperature sensor is located by the O2 sensor.
What position is the crank sensor on a f250 ford pickup
O2 Sensor stuck lean bank 2, sensor 2.
where is the location of the vin number on a 250 king quad