The torque specifications are actually determined by the bearing manufacturer.
However 148 ft-lbs or 200 Nm seems to be the common spec.
The lug nut torque specification for a 2002 Sunfire is 90 foot pounds. This is assuming that the rims are factory stocked, as rims with different masses may require different torque settings.
184 pounds of torque
The 3 bolts on the hub are 65 foot pounds, and the axle nut is 165 foot pounds.
Here is a site with that info, and for a lot of other vehicles: http://www.aera.org/downloads/Torque3.pdf
The short bolt torque specs for the head gasket of a 2000 Pontiac Sunfire is 43 foot pounds. The torque specs for long bolts is 46 foot pounds.
Torque settings for main bearings and big end bearings
polo torque settings 1200 engine main bearing
what is the torque setting for big ends and main bearing on a 2.5tdi ford ranger
192foot pounds
what are head bolt torque rod bearing cap torque on k4n mitsubishi
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
In order to wire the starter on a Pontiac Sunfire, you will need a jack, jack stand, socket set, and a torque wrench. You will need to make sure to remove the battery cables from the battery.