0
What is the torque spec for wheel bearing on 2003 Pontiac aztek?
Wiki User
∙ 12y ago
192foot pounds
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Torque spec for wheel bearing nut 2003 grand prix?
The 2003 Pontiac Grand Prix wheel bearing nut torque specification is 40 pounds. Do not exceed the 40 pound specification or you will risk causing the wheel seal to fail.
Ehat are the torque wheel bearing settings for 2002 Pontiac sunfire?
The torque specifications are actually determined by the bearing manufacturer. However 148 ft-lbs or 200 Nm seems to be the common spec.
ABS and traction control light stays on at all times on a 2003 Pontiac Aztek?
Chances are its a wheel speed sensor and will need the wheel bearing replaced. or it can be a loose or corroded wire attached to the sensor as well.
What is the wheel bearing torque for a Renault traffic r reg?
Front hub/wheel bearing torque is 190-210Nm.
What is the recommended torque setting on Honda Accord rear wheel bearing?
The Honda accord rear will bearing should be torqued at 60 pounds. You can ruin the wheel bearing or the wheel seal if you over torque the wheel bearing nut.
How do you find out which wheel bearing is bad on a 2001 Pontiac grand am gt?
how do you find out if wheel bearing is bad on a 2001 grand am gt
What is the wheel bearing torque specs in ftlbs on a rear wheel bearing for a 1998 Honda Accord?
what is the torque on front wheel bearings for 1998 honda accord
What is the Torque on a 97 f250 wheel bearing?
The 1997 Ford F2 50 pickup truck wheel bearing torque specification is 60 pounds. Over torquing the wheel bearing will cause it to fail.
What is the size of the center front wheel hub nut its torque rating on a 2001 Pontiac Aztek?
192 POUNDS torque or 260nmGo to http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0996b43f80cb33b8AnswerI found out by trial and error that the center front wheel hut nut is 33mm. Not sure what the torque rating is. AnswerI found out by trial and error that the center front wheel hut nut is 33mm. Not sure what the torque rating is. wheel nut size for a 2001 aztek is 35 mm. general rule of thumb is finger tight, spin wheel and tighten nut till it stops. the torque value should be include with the manufacturer of the assembly.
Front wheel bearing torque specs 2000 Pontiac Montana?
96 lbs for the three small bolts in the back I think the axle nut is 175?
What is the wheel bearing torque on a Saturn vue?
front bearing torque 151 ft lb rear bearing torque 63 ft lb plus 36 degrees
What is the wheel bearing torque 1999 S10?
90psi
