How do i remove the steering wheel cover to get at the horn contacts on a 1999 chev s10 You will be messing with the air bag and I recommend having a knowledgeable mechanic help you with this one.
Car is front wheel drive, S10 is rear wheel. Last I knew, there were no holes for the motor mounts on the car motor. The spot is there on the block, but the holes are not tapped.
Considering the Silverado has a 6 lug rim and the S10 has a 5 lug rim, it would be an expensive project to convert the 5 lug S10 into the 6 lug pattern of the Silverado.
Try 15rims.com
That's as easy as it gets in the transmission world. If you are mechanically inclined just figure it out. If not, don't touch it.
The torque specs for a 2003 Chevy S10 4x4 wheel bearing is 28 ft. lbs. This is equal to 38 N.m.
Brakes are shot or a wheel bearing is bad.
Any Auto Parts Store will sell you one.
35mm.
sealed non greasable bearings would be around 65 ft lbs greaseable bearings are just snug up tight w/channel locks then back off slightly to where the nearest cotter pin hole is to allow for heat and expansion of the bearing assembly
how to drai torque converter on 1999 chevy blazer
Front wheel bearing(s).
35mm.
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearings.
There is no fixing it, it must be replaced.
The front axle nut would be a 35mm.
Yes it is . The only difference may be drum or disc brakes.