Want this question answered?
Horizontal line
Primer bulbs on small engines take the place of a choke on the carb . If your carb has a choke on it then you could probably bypass it . The object of the primer and the choke is to give the engine a extra charge of gas to help it start when the engine is cold . If you take this away then the engine will be hard starting if it starts at all .
The choke enriches the mixture for start-up and then is heated by a small electrical heating coil so the choke goes off when the engine is at operating temperature.
You can get an automatic choke for small engines at most hardware stores that sell mower parts. You can also find this item at many small engine repair shops or even golf cart shops.
Could be that the air/fuel mixture is set too lean. Needs adjustment.
Small objects, like small fish bones, can cause you to choke.
Technically anyone could choke ; but kids who are small choke because it's easier for them since they're throat is skinny'er than anyone older .
An automatic choke is connected to the carburetor on small engines. To get a new automatic choke, a new carburetor will need to be purchased. It is easier to install a manual choke and less costly. Kits for this are sold at most automotive repair stores.
how do you hook up a manuel choke on a small block chevy
Small children could choke on them.
yea easy job if its a carb.but the car engine must be cold when adjusting.both electronic and water chokes are held on by a pinch ring with 3 small screws, loosen the screws so the choke turns.turn the choke until the tension on the choke butterfly (the brass flap on top of the carbs primary venturi) loosens ( keep tapping the butterfly down to check tension) if the tension increases ur turning the wrong way if the butterfly opens your going the right way but you've gone too far the butterfly should be only just closed.if u mean the idle speed when cold is too high (sounds like over revving) then there is a small screw located behind the choke mechanism located this first u may need a small mirror then start the car and turn the screw until the engine revs about 1200 rpm but be quick and don't rev the engine or the choke will come off and revs will lower anyway so u need to switch off the engine and wait for it to cool a little bit b4 re adjustinghope this helps
Not really because it is way too small to even choke on you might swallo it but 50% you won't need to worry