The 4017 IC is a decade (divide by ten) counter with decoded outputs. Internally, there is a 4 bit counter, with feedback to reset at 10 instead of 16, followed with a ten output decoder that makes each state available on a separate pin of the IC.
Another answer
One of my favorite IC's, the 4017 decade counter/divider.
The 4017 takes a clock pulse in and then steps the output from negative to positive in a series of ten steps, with only one pin being on at a time. It has the unique capability of counting up to a certain number and then restarting the count, counting up to a certain number and halting, or it can be cascaded to more 4017's for a higher count.
The outputs are labeled 0 through 9. It can sink about 10 ma. of current per pin and is a very versitile IC. It operates from 3 VDC. to 15 VDC.
Do a Google search and in parenthesis type in "LM4017". You'll be rewarded with all kinds of technical info which you can download and print.
hey my name is satan.. my number 919986870251
output drive capability-10lsttl loads
outputs directly interface to c mos,nmos,and ttl,
large operatingvoltage range
low input curent
high noise immunitry
can i use ic 7476 as time delay
When using a common cathode 7-segment display with a 7447 the readout is inverted. Instead of 1000 resulting in an 8, you will see all segments will be off. Since a common cathode display pulls its power from the driving IC chip you could either use an inverter on each input segment or use each 7447 output to forward bias a transistor (turn it on) allowing current draw to come directly from Vcc instead of risking burning out your chip. Note: the series limiting resistors will still be necessary.
you must be dirrectly cnnect to 74ls192
IC Bus was created in 2002.
In linear IC'S the output voltage is very according to input voltage In digital IC's the output voltage is either high or low
can i use ic 7476 as time delay
7400
When using a common cathode 7-segment display with a 7447 the readout is inverted. Instead of 1000 resulting in an 8, you will see all segments will be off. Since a common cathode display pulls its power from the driving IC chip you could either use an inverter on each input segment or use each 7447 output to forward bias a transistor (turn it on) allowing current draw to come directly from Vcc instead of risking burning out your chip. Note: the series limiting resistors will still be necessary.
8474
The sum of 7,447 and 1,027 is 8,474.
The IC code is on the actual IC, you can find out its details by searching the IC code on Google.
ic made from bjt is known as bipolar ic
op amp linear ic 7805 non linear ic
The letters "IC" pronounced properly can say "icy" meaning very cold.
Both IC 7805 & IC 7905 are voltage regulators, IC 7805 is Ic 78xx series while IC 7905 is Ic 79xx series with xx representing voltage output
you must be dirrectly cnnect to 74ls192
naming of IC is done according to manufacturer's name, ic type and IC number. i think MC means motorola is manufacturer. 74 means TTL IC. It is 7408 IC and H means high