fyhgyguoi fyhgyguoi
The resistance force multiplied by the resistance distance.
I have no clue what is this!Why do I have to type?
Step Potential is the potential Difference between two points on the earth's surface, separated by distance of one pace, that will be assumed to be one meter in the direction of maximum potential gradient (IS 3043) Touch Potential is the potential difference between a grounded metallic structure and a point on the earth's surface separated by a distance equal to the normal maximum horizontal reach, approximately one meter. (IS 3043)
To measure resistance, you could use an ohmmeter. But ohmmeters are not particularly accurate, so other methods are preferable. These include the use of Wheatstone's Bridge (which compares the unknown resistance with known values) or a Ducter (for very low resistances).
Ohm's original law was 'The potential difference across a conductor is proportional to the current flowing through it, provided physical conditions such as temperature remain constant.'Today Ohm's law is expressed as E = IR or sometimes V = IR,the units being Volts, Amps and Ohms.AnswerOhm's Law ('the current flowing along a conductor, at constant temperature, is directly proportional to the potential difference across that conductor') only applies when the resistance of the conductor is constant so, when verifying Ohm's Law, the temperature must be kept constant, in order to keep the resistance constant.It should be pointed out that the ratio of voltage (U) to current (R) is called resistance (R), and the resistance of a circuit can be found from the equation, R = U/I whether Ohm's Law applies or not -but Ohm's Law itself only applies when the ratio is constant over a range of voltage variation.
Kinetic and potential energy are a type of energy, not a measurement of distance.
Measurement always deals with a distance of a line or a distance between to objects, distance between 2 points, and so on.
The base SI unit of distance is the meter.
Latitude is the measurement of distance north or south of the Equator. Longitude is the measurement of distance east or west of the prime meridian.
line measurement- distance between two lines end measurement- distance between two faces
length / distance
Meters
Effort, resistance
resistance,effort
It is a measurement that doesn't have direction, such as distance. A vector has direction
what is the distance measurement?
Length. Distance.